Datasheet

Installation5RMI0-02A
123
Inverter Single
According to the confirmation of the above conditions,
prepare the wiring as follows.
1. Never fail to have an individual power circuit specifically
for the air conditioner. As for the method of wiring, be
guided by the circuit diagram posted on the inside of
control cover.
2. The screw which fasten the wiring in the casing of
electrical fittings are liable to come loose from
vibrations to which the unit is subjected during the
course of transportation. Check them and make sure
that they are all tightly fastened. (If they are loose, it
could cause burn-out of the wires.)
3. Specification of power source.
4. Confirm that electrical capacity is sufficient.
5. See that the starting voltage is maintained at more than
90 percent of the rated voltage marked on the name
plate.
CAUTION
Provide the circuit breaker between power source and
the unit as shown by
CAUTION
Cover control
Outdoor UnitOutdoor UnitOutdoor Unit
Connecting
cable
1(L) 2(N) 1(L) 2(N) 3
Air
Conditioner
Main power source
Circuit Breaker
Use a circuit breake
or time delay fuse.
6. Confirm that the cable thickness is as specified in the
power source specification. (Particularly note the
relation between cable length and thickness.
7. Always install an earth leakage circuit breaker in a wet
or moist area.
8. The following would be caused by voltage drop.
- Vibration of a magnetic switch, which will damage the
contact point, fuse breaking, disturbance of the
normal function of the overload.
9. The means for disconnection from a power supply shall
be incorporated in the fixed wiring and have an air gap
contact separation of at least 3mm in each
active(phase) conductors.
10. Open the terminal cover block before connecting the
indoor side wire.
Finishing the indoor unit installation
1. Mount the tubing holder in the original positon.
2. Ensure that the hooks are properly seated on the
installation plate by moving it left and right.
3. Press the lower left and right sides of the unit against
the installation plate until the hooks engage into their
slots (clicking sound).
4. Finish the assembly by screwing the unit to the
installation plate by using two pieces of type "C"
screws. And assemble a chassis cover.
Type 'C' screw