Datasheet

Installation 5RMI0-02A
102
Inverter Single
Finishing the indoor unit
installation
1 Assemble the clamp for piping and screw it up.
2 Assemble the terminal block cover.
3 Screw up the terminal block cover as the initial
condition. (Screw up the terminal block cover and the
inlet grille with type “C” screw at “a” position, and the
terminal block cover and the case with the ground
screw at “b” position.)
4 Finish the assembly by screwing the unit to the
installation plate by using two pieces of type "C"
screws.
5 Assemble the service cover and screw it up.
6 Assemble the front panel.
Clamp
Type C
(“a” position)
Ground Screw
(“b” position)
Front panel