Datasheet

Installation 5RMI0-02A
100
Inverter Single
Installation of Indoor Unit
Hook the indoor unit onto the upper portion of the
installation plate.(engage the two hooks at the top of the
indoor unit with the upper edge of the installation plate)
Ensure that the hooks are properly seated on the
installation plate by moving it left and right.
* The feature can be changed according to a type of
model.
Piping
1 Insert the connecting cable through the bottom side of
indoor unit and connect the cable (You can see detail
contents in Connecting the cables section)
2 Secure the cable onto the control board with the cable
retainer.
3 Tape the tubing pipe, drain hose and the connection
cable. Be sure that the drain hose is located at the
lowest side of the bundle. Locating at the upper side
can cause overflow from the drain pan through the
inside of the unit.
Connecting
cable
Gas side piping
Liquid side piping
Drain hose
Loop
Boss
Prop
BR BL
GN/YL
BK
Terminal
block
Connecting
cable
Cable retainer
Connecting
cable
Gas side piping
Liquid side piping
Drain hose
Loop
<Right side piping>
<Left side piping>
Ensure that you put the boss of the chassis on the prop
of the installation plate and mate the hole of the
chassis with the hole of the installation plate.
CAUTION
If the drain hose is routed inside the room, insulate the
hose with an insulation material* so that dripping from
"sweating"(condensation) will not damage furniture or
floors.
* Foamed polyethylene or equivalent is recommended.
CAUTION