Owners Manual

36 OPERATION
Special Functions
Some cycle option buttons also activate secondary
functions. These special functions are marked with an
asterisk (*). Press and hold the option button marked
with the special function to activate it.
Child Lock
Use this option to prevent unwanted use of the dryer
or to keep cycle settings from being changed while
the dryer is operating.
Activating the Child Lock Function
Press and hold the Child Lock button for 3 seconds.
The Child Lock icon will be shown in the display, and
all controls will be disabled except the Power button.
Deactivating the Child Lock Function
Press and hold the Child Lock button for 3 seconds.
Once set, Child Lock remains active until it is
manually deactivated. Child Lock must be turned off
to run another cycle.
Custom PGM
Save special combinations of settings that are used
frequently as a custom program.
Saving a Custom Program
1
Turn on the dryer and select the desired settings
using the cycle selector knob and cycle modier
or option buttons.
2
Press and hold the Custom PGM button for
three seconds.
NOTE
• Only one custom program can be saved at a time.
Pressing and holding the Custom PGM button will
overwrite any previously saved custom program.
Recalling a Custom Program
1
Turn on the dryer and press the Custom PGM
button.
2
Press the Start/Pause button to start the cycle.
Rack Dry (On Some Models)
Use the Rack Dry function with items, such as wool
swearters, silk items, and lingerie, that should be
dried at. Rack Dry can also be used with items that
should not be tumbled dry, such as gym shoes or
stuffed animals.
NOTE
• NEVER tumble dry a load of clothing with the rack
installed.
• When the rack is installed, the drum will rotate as
usual, but the rack will not move. Make sure all
articles to be dried remain completely on the rack
and cannot fall off or be pulled off by the turning
drum. Be sure to remove the rack after use.
Using the Rack Dry Cycle
1
With the dryer door open, slide the rack into the
dryer drum.
2
Make sure it is seated evenly on the edge of the
inner door rim and resting at on the inside of
the dryer.
3
Place wet items on the rack. Allow space around
the items for air to circulate.
4
Close the door and select Rack Dry.
5
Press Temp. Control to select a temperature
option. If no temperature is selected, Rack Dry
defaults to no heat.