Owner's Manual Spanish 07/18/2017 15618K
Table Of Contents
- PRODUCT FEATURES
- SAFETY INSTRUCTIONS
- PRODUCT OVERVIEW
- INSTALLATION
- Installation Overview
- Product Specifications
- Installation Location Requirements
- Clearances
- Leveling the Dryer
- Reversing the Door
- Installing the Side Vent Kit
- Stacking the Dryer
- Venting the Dryer
- Connecting Gas Dryers
- Connecting Electric Dryers
- Special Electrical Requirements
- Final Installation Check
- Installation Test (Duct Check)
- OPERATION
- SMART FUNCTIONS
- MAINTENANCE
- TROUBLESHOOTING
- WARRANTY
- CARACTERÍSTICAS DEL PRODUCTO
- INSTRUCCIONES DE SEGURIDAD
- DESCRIPCIÓN GENERAL DEL PRODUCTO
- INSTALACIÓN
- Descripción general de la instalación
- Especificaciones del producto
- Requisitos del lugar de instalación
- Espacios libres
- Nivelación de la secadora
- Inversión de la puerta
- Instalación del kit de ventilación lateral
- Apilamiento de la secadora
- Ventilación de la secadora
- Conexión de secadoras de gas
- Conexión de secadoras eléctricas
- Requisitos eléctricos especiales
- Revisión final de la instalación
- Prueba de instalación (Revisión de conductos)
- FUNCIONAMIENTO
- FUNCIONES INTELIGENTES
- MANTENIMIENTO
- SOLUCIÓN DE PROBLEMAS
- GARANTÍA
52 TROUBLESHOOTING
Steam Functions (Steam Models)
Problem Possible Cause Solutions
Water drips from nozzle when
STEAM CYCLE starts
This is normal.
• This is steam condensation. The
dripping water will stop after a short
time.
Garments still wrinkled after Steam
Fresh™
Too many or overly different
types of garments in dryer.
• Small loads of 1 to 5 items work best.
Load fewer garments. Load similar
types of garments.
Creases or pleats are gone from
garments after Steam Fresh™
The function of this cycle is to
remove wrinkles from fabric.
• Use an iron to replace creases and
pleats in garments.
Garments have static after using the
Reduce Static option
This is normal.
• The amount of static experienced will
depend on the individual moisture
level in the skin.
Garments are too damp or too dry
after using the Reduce Static option
Correct drying options not
selected.
• Select the load weight manually
before starting the Reduce Static
option.
Garments are not uniformly damp
after using the Easy Iron option
Number of garments or load
size not properly selected at
the beginning of the cycle.
• Select the correct number of
garments or load size before starting
the cycle.
Steam does not generate, but no
error code is shown
Water level error. • Unplug dryer and call for service.
Water drips from door during
STEAM CYCLE
This is normal.
• Condensation will normally form on
the inside of the dryer door during
steam operation. Some condensation
may drip out the bottom of the door.
Steam is not visible during STEAM
CYCLE
This is normal.
• Steam vapor is difcult to see
when the door is closed. However,
condensation will normally form on
the inside of the dryer door if the
steam system is operating normally.
Drum does not turn during STEAM
CYCLE
This is normal.
• The drum is turned off so that the
steam vapor remains in the drum.
The drum will normally turn for about
2 seconds once a minute.
Cannot see steam vapor at the
beginning of cycle
This is normal.
• Steam is released at different stages
of the cycle for each option.
Odors remain in clothing after
Steam Fresh™
Steam Fresh™ did not remove
odor completely.
• Fabrics containing strong odors
should be washed in a normal cycle.