Owner's Manual Spanish 07/18/2017 15618K
Table Of Contents
- PRODUCT FEATURES
- SAFETY INSTRUCTIONS
- PRODUCT OVERVIEW
- INSTALLATION
- Installation Overview
- Product Specifications
- Installation Location Requirements
- Clearances
- Leveling the Dryer
- Reversing the Door
- Installing the Side Vent Kit
- Stacking the Dryer
- Venting the Dryer
- Connecting Gas Dryers
- Connecting Electric Dryers
- Special Electrical Requirements
- Final Installation Check
- Installation Test (Duct Check)
- OPERATION
- SMART FUNCTIONS
- MAINTENANCE
- TROUBLESHOOTING
- WARRANTY
- CARACTERÍSTICAS DEL PRODUCTO
- INSTRUCCIONES DE SEGURIDAD
- DESCRIPCIÓN GENERAL DEL PRODUCTO
- INSTALACIÓN
- Descripción general de la instalación
- Especificaciones del producto
- Requisitos del lugar de instalación
- Espacios libres
- Nivelación de la secadora
- Inversión de la puerta
- Instalación del kit de ventilación lateral
- Apilamiento de la secadora
- Ventilación de la secadora
- Conexión de secadoras de gas
- Conexión de secadoras eléctricas
- Requisitos eléctricos especiales
- Revisión final de la instalación
- Prueba de instalación (Revisión de conductos)
- FUNCIONAMIENTO
- FUNCIONES INTELIGENTES
- MANTENIMIENTO
- SOLUCIÓN DE PROBLEMAS
- GARANTÍA
27INSTALLATION
ENGLISH
Installation Test (Duct Check)
Once you have completed the installation of the
dryer, use this test to make sure the condition of the
exhaust system is adequate for proper operation of
the dryer. This test should be performed to alert you
to any serious problems in the exhaust system of
your home.
• Your dryer features Flow Sense™, an innovative
sensing system that automatically detects
blockages and restrictions in dryer ductwork.
Keeping ductwork clean of lint buildup and free of
restrictions allows clothes to dry faster and reduces
energy use.
NOTE
• The dryer should be cool before starting this test.
If the dryer was warmed up during installation, run
the AIR DRY cycle for a few minutes to reduce the
interior temperature.
Activating the Installation Test
1
Remove the drying rack and literature, and
then close the door.
Do not load anything in the drum for this test, as
it may affect the accuracy of the results.
2
Press and hold the Signal and Temp. Control
buttons and then press the Power button.
(On models with a glass touch control panel,
press the Power button then IMMEDIATELY
press and hold the Temp. Control and Signal
buttons.)
This button sequence activates the installation
test. The code
will display if the activation
is successful.
3
Press the Start/Pause button.
The dryer will start the test, which will last a
few minutes. The heat will be turned on and the
temperatures in the drum will be measured.
4
Check the display for results.
During the test cycle, monitor the Flow Sense™
display on the control panel. If no bars are
displayed when the cycle ends, the exhaust
system is adequate. If the exhaust system is
severely restricted, the display will show four
bars. Have the system checked immediately, as
performance will be poor. Other problems may
also be shown with error codes. Refer to the the
Error Code table for details and solutions.
NO BARS: OK FOUR BARS:
RESTRICTED
5
End of cycle.
At the end of the test cycle,
will display.
The test cycle will end and the dryer will shut off
automatically after a short delay.