Owner’s Manual
Table Of Contents
- IMPORTANT SAFETY INSTRUCTIONS
- PRODUCT OVERVIEW
- INSTALLATION
- Before Installing
- Installing the Cooktop
- Electrical Connections
- Important Safety Instructions
- Providing the Electrical Connection
- Electrical Requirements
- Electrical Connection
- Where Local Codes Permit Connecting the Appliance-Grounding Conductor to the Neutral (White) Wire
- If Cooktop is Used in a New Branch Circuit Installation (1996 NEC), Mobile Home, Recreational Vehicle, or where Local Codes Do Not Permit Grounding to the Neutral (White) Wire
- Installing the Cooktop Unit
- Final Check
- Electrical Connections
- OPERATION
- SMART FUNCTIONS
- MAINTENANCE
- TROUBLESHOOTING
- LIMITED WARRANTY
11INSTALLATION
ENGLISH
Preparing the Installation Location
Important Installation Information
• All electric cooktops run off a single phase, three-wire or four-wire cable, 240/208 volt, 60 hertz, AC-only
electrical supply with ground.
• Minimum distance between cooktop and overhead cabinetry is 30" (762 mm).
• Make sure the cabinets and wall coverings around the cooktop can withstand the temperatures (up to 93
℃ [200 ℉]) generated by the cooktop.
Dimensions and Clearances
a Do not obstruct these areas.
b Right side
c Radius: 3/8" (10 mm)
d 4″ X 8″ (102 mm x 203 mm) opening to route armored cable if panel is present.
e Approximate location of junction box
- Dimension/Clearance 36" Cooktop
A Width of upper plate 36 5/8" (930 mm)
B Depth of upper plate 21 1/16" (535 mm)
C Distance from bottom of upper plate to bottom of conduit 3 7/16" (87 mm)
D Width of cooktop base 33 7/8" (860 mm)
E Depth of cooktop base 19 5/16" (490 mm)
F Distance from bottom of upper plate to bottom of cooktop base 2 5/16" (58 mm)
A
B
C
D
C
E
F
G
H
I
J
K
L
M
N
O
P
O
QR
S
T
U
K