Owner’s Manual
Table Of Contents
- IMPORTANT SAFETY INSTRUCTIONS
- PRODUCT OVERVIEW
- INSTALLATION
- Before Installing
- Installing the Cooktop
- Electrical Connections
- Important Safety Instructions
- Providing the Electrical Connection
- Electrical Requirements
- Electrical Connection
- Where Local Codes Permit Connecting the Appliance-Grounding Conductor to the Neutral (White) Wire
- If Cooktop is Used in a New Branch Circuit Installation (1996 NEC), Mobile Home, Recreational Vehicle, or where Local Codes Do Not Permit Grounding to the Neutral (White) Wire
- Installing the Cooktop Unit
- Final Check
- Electrical Connections
- OPERATION
- MAINTENANCE
- TROUBLESHOOTING
- LIMITED WARRANTY
12 INSTALLATION
All dimensions are stated in inches and millimeters (mm).
Allow 2" (50 mm) below the armored cable opening to clear the electric cable and allow space for
installation of the junction box on the wall at the back of the cooktop.
CAUTION
• To eliminate the risk of burns or fire by reaching over heated surfaces, cabinet storage space located
above the cooktop should be avoided. If cabinet storage is provided, risk can be reduced by installing a
range hood that projects horizontally a minimum of 5" (127 mm) beyond the face of the cabinets.
• It is very important to keep 2" (51 mm) distance between the cooktop and an oven installed below it.
Installing the Cooktop
Electrical Connections
Important Safety Instructions
• Be sure the cooktop is installed and grounded
properly by a qualified installer or service
technician.
• This cooktop must be electrically grounded in
accordance with local codes or, in their absence,
with the National Electrical Code ANSI/NFPA No.
70, latest edition in the United States.
WARNING
• The electrical power to the cooktop must be shut
off while line connections are being made.
Failure to do so could result in serious injury or
death.
Providing the Electrical Connection
• Install the junction box under the cabinet and
run 120/240 or 120/208 Volt, AC wire from the
main circuit panel.
J Height below cutout
(Empty space is needed underneath the cooktop for installation
purposes.)
2 4 3/16" (107 mm)
K Distance from front of counter to front edge of cutout
2 1 1/2" (38 mm)
L Junction box (approximate location)
1 10" (254 mm)
M Junction box (approximate location)
2 15" (381 mm)
N Depth of overhead cabinets
1 13" (330 mm)
O Cut area and backwall of cooktop
2 1 1/8" (28 mm)
P Clearance from top of cooking surface to bottom of overhead cabinets
230" (762 mm)
Q Clearance from countertop to bottom of adjacent cabinets
218" (457 mm)
R Height of conduit 1" (26 mm)
- Dimension/Clearance CBED2415B