Owner’s Manual
Table Of Contents
- IMPORTANT SAFETY INSTRUCTIONS
- PRODUCT OVERVIEW
- INSTALLATION
- Before Installing
- Installing the Cooktop
- Electrical Connections
- Important Safety Instructions
- Providing the Electrical Connection
- Electrical Requirements
- Electrical Connection
- Where Local Codes Permit Connecting the Appliance-Grounding Conductor to the Neutral (White) Wire
- If Cooktop is Used in a New Branch Circuit Installation (1996 NEC), Mobile Home, Recreational Vehicle, or where Local Codes Do Not Permit Grounding to the Neutral (White) Wire
- Installing the Cooktop Unit
- Final Check
- Electrical Connections
- OPERATION
- MAINTENANCE
- TROUBLESHOOTING
- LIMITED WARRANTY
11INSTALLATION
ENGLISH
Preparing the Installation Location
Important Installation Information
• All electric cooktops run off a single phase, three-wire or four-wire cable, 240/208 volt, 60 hertz, AC-only
electrical supply with ground.
• Minimum distance between cooktop and overhead cabinetry is 30" (762 mm).
• Make sure the cabinets and wall coverings around the cooktop can withstand the temperatures (up to 90
℃ [194 ℉]) generated by the cooktop.
Dimensions and Clearances
a Do not obstruct these areas.
b Approximate location of junction box
- Dimension/Clearance CBED2415B
A Width of upper plate 23 5/8" (600 mm)
B Depth of upper plate 20 7/16" (520 mm)
C Height of cooktop base 2 3/16" (56 mm)
D Width of cooktop base 21 9/16" (548 mm)
E Depth of cooktop base 18 7/16" (468 mm)
F Width of cutout 22" - 22 1/8" (558 mm - 562
mm)
G Depth of cutout 18 13/16" - 19" (478 mm -
482 mm)
H Distance from side edge of cutout to side of counter
2 1" (26 mm)
I Distance from edge of cooktop to nearest combustible wall (either side
of unit)
1" (26 mm)