Install Instructions

ManualsBrandsLG ManualsHVAC Supplies42" x 18" Deep Insulated Wall Sleeve for PTAC

DO NOT remove the thermal insulation from sleeve.

Extended Metal Wall Sleeve

Packaged Terminal Air Conditioner

Installation Instructions

INTRODUCTION

These instructions cover installation of the

extended metal

wall sleeve

through masonry, steel or wood frame walls. Fasteners are field

supplied.

The sleeve is shipped disassembled. It must be field assembled prior to

installation.

Note: a corrugated weather barrier is also included. If required, it

can be attached to the rear of the sleeve to provide temporary

weather protection.

Air conditioner and rear grille are shipped separately.

PACKAGE CONTENTS

Bottom Panel

Air Separator Panels

Left Side Panel

Screws (Stainless Steel)

Right Side Panel

Weather Barrier

Top Panel

Push Pins

WALL SLEEVE ASSEMBLY

Step 1 - Set Bottom Panel on a clean flat and level surface.

Step 2 - Locate Left Side Panel. Align panel in the Left Bottom

Panel slot. Fully insert Left Panel into Bottom Panel until

locking tabs engage.

Front View

Step 3 - Locate Right Side Panel. Align panel in the Right

Bottom Panel slot. Fully insert Right Panel into Bottom Panel

until locking tabs engage.

Front View

Step 4 - Locate Top Panel and align with top of Right and Left

Side Panels. Fully insert Top Panel into Right and Left Side

Panels until locking tabs engage.

Front View

Step 5 - Locate two Air Separator Panels and align with slides in

the Top and Bottom Panels. Insert (4) supplied screws to secure

Air Separator Panels. Smaller lip of Air Separator Panel with foam

attached should be faced towards the back of the wall sleeve.

Step 6 - (If required) Locate Weather Barrier and attach to the rear of the

assembled sleeve with four (4) supplied push pins.

Finished Assembly - Front View

Manufacturer reserves the right to discontinue, or change at any time, specifications or designs without notice and without incurring obligations.

Catalog No. FAP112-2000-01 Printed in U.S.A. Form Extended Steel Sleeve 12-18-2015 Pg 1

Air Separator

Panels

Top Panel

Slides

Bottom Panel

Slides

Summary of content (2 pages)

PAGE 1
Extended Metal Wall Sleeve Packaged Terminal Air Conditioner Installation Instructions INTRODUCTION These instructions cover installation of the extended metal wall sleeve through masonry, steel or wood frame walls. Fasteners are field supplied. The sleeve is shipped disassembled. It must be field assembled prior to installation. Step 4 - Locate Top Panel and align with top of Right and Left Side Panels. Fully insert Top Panel into Right and Left Side Panels until locking tabs engage.
PAGE 2
SELECTING SLEEVE LOCATION Use the following guide for selecting the proper sleeve location: 1. 2. 3. Allow at least 14 inches from front of wall sleeve for removal of front panel and air conditioner for maintenance. The sleeve may be installed flush against the floor (including carpeting), except for installations using a subbase. See SUBBASE INSTALLATIONS section below. For cord-connected air conditioners, an electrical receptacle must be located within reach of power cord.