Owner's Manual

35
Cleaning the Dust Sensor
PM 1.0 (super ultra-ne dust) sensor
detects the ne dust as well as coarse
dust. Therefore, you need to clean its lens
regularly.
1
Remove the rear cover from the
product.
•
For more information on how to
remove and mount the cover,
please see Removing Packing
Materials.
2
Open the sensor cover.
3
Clean the lens with the cotton swab
soaked with water and clean it again
with a dry cotton swab.
4
Close the sensor cover.
Note
Do not wipe the sensor with material other
than water. It may cause a product failure.
Storage
If the product is not used for a long period of
time, store it at a shaded and dry place.
1
Operate the product in Normal mode
for one hour or more on a ne day.
•
This removes the moisture and
prevents molds from building up
inside the product.
2
Turn o the power and unplug it from
the electrical outlet.
•
Wind the power cord around the
bottom of the product.
Note
The shape of the power plug diers
depending on the country.