Owner's Manual

14
CAUTION
•
Avoid dropping the product and parts when taking them
out of the package. It may damage the product and/or
cause personal injury.
•
Do not use double-sided tape to anchor the charging
station on papered walls. Please use the provided screws
as otherwise the wall paper will get torn by movement
of the charging station during the docking of the unit.
•
We recommend anchoring the station with the
anchoring screw.
•
Use the anchoring screws only when the wall is made
of concrete or is solid enough. An unsuitable wall
can cause the mountings to weaken and cause the
Charging station to fall causing injury and damage the
property or product.
Please note
•
The charging station, its pipe and support cannot
be disassembled separately once they have been
assembled, and the charging station has been
attached to the wall.
•
The charging station can be removed as needed. After
unscrewing it from the wall, pull the station upward whilst
the bottom of the station remains upright on the floor.
Installing the wall-mount station
1
Connect the power adapter to the port on the back
of the charging station and plug the power cord
into the power outlet.
2
Make a hole 1 meter from the floor to insert the
wall plug or screw anchor.
•
Recommended diameter of hole:
Φ
6.5;
Recommended depth: 60 mm.
3
Anchor the station to the wall with the provided
anchoring screws.
1
Wall anchoring
hole
Anchoring
screw for wall-
mount type
Screw
anchor
Please note
•
A service request to change the installation location
of the charging station will incur additional costs if
required to do so by a qualified installer.
Uninstalling the station
Keep and charge the product on the charging station
after separating extension pipe and nozzle from the
product body.
CAUTION
•
Leaving the extension pipe and nozzle assembled for a
long time may cause damage the product.
Storage of the combination tool
and crevice tool
Keep the combination tool and crevice tool on the
charging station for easy access.
1
Attach the combination tool and crevice tool to the
dedicated holders.
2
Press and hold the inlet removal button and pull
downward to remove the combination tool or
crevice tool.
1 MFL69883607_en_180405.indd 14 2018-04-05 오후 1:54:19