Owner's Manual

13
EN
INSTALLATION
Installing the floor standing
charging station
1
Put the bottom of the charging station onto the
floor and assemble the pipe first, followed by the
upper body mount.
CAUTION
•
Avoid getting your fingers stuck in any gap.
2
Connect the power adapter to the port on the back
of the charging station and plug the power cord
into the power outlet.
•
The cord can be secured tidily by putting it
through the power cord anchoring ring located
on the back of the charging station pipe.
①
②
3
After ensuring there are no pipes or wires insider
behind the wall, make a hole at the appropriate
height to anchor the charging station and insert
the screw anchor.
•
Recommended diameter of hole:
Φ
6.5;
Recommended depth: 100 mm.
Screw anchor
4
Put the anchoring block on the back of the charging
station and anchor the charging station with the
screw.
•
Make sure to fully tighten the screw.
Anchoring screw
for standing type
Wall anchoring block
Screw
anchor
When using double-sided tape (do not use
if the wall is wallpapered)
1
Use double-sided tape to attach the wall anchoring
block to the charging station in step 4.
•
Be sure to remove the center part of the double-
sided tape before mounting it.
Wall anchoring block
2
Use the remaining part of the tape to anchor the
station to the wall before inserting the screw.
1 MFL69883607_en_180405.indd 13 2018-04-05 오후 1:54:18