Owner's Manual

ADVANCED FUNCTIONS
17
ENGLISH
Room temp. Set temp.
Operation
mode
Below 21°C 24°C
Heating
operation
Above 21°C
and below
24°C
23°C
Dehumidify-
ing operation
Above 24°C 22°C
Cooling
operation
- For cooling and heating models, the oper-
ation mode changes, depending on the
room temperature.
1 Open the front panel.
- Lift up both sides of the cover slightly.
* The feature can be changed according to a
type of model.
2 Press the On/Off button.
* The feature can be changed according to
a type of model.
In case of turning Off
Restarting the air conditioner
automatically
When the air conditioner is turned on again
after a power failure, this function restores the
previous settings. This function is a factory de-
fault setting.
1 Open the front cover.
- Lift up both sides of the cover slightly.
2 Press the On/Off button and hold it for 6
seconds.
- The unit will beep twice and the lamp will
blink twice 4 times.
- To re-enable the function, press the On/
Off button and hold it for 6 seconds. The
unit will beep twice and the blue lamp will
blink 4 times.
Disabling auto restart
NOTE
!
• If you press and hold the On/Off button
for 3 – 5 seconds instead of 6 seconds,
the unit will switch to the test operation.
• In the test operation, the unit blows out
strong air for cooling for 18 minutes and
then returns to the factory default set-
tings.
* The feature can be changed according to
a type of model.
* The feature can be changed according to
a type of model.