Troubleshooting Guide

49TROUBLESHOOTING
ENGLISH
Washer is not filling
properly.
Filter is clogged.
ll valves are not clogged. Refer to Cleaning the Water
Inlet Filters in MAINTENANCE.
Inlet hoses may be kinked.
Energy efficiency
sult, the water level settings for this washer
may be different than for conventional washer.
Insufficient water supply
ter faucets are turned on all the way.
Washer door is open.
closing completely.
Water level is too low.
cover the clothes. The fill level is optimized for the wash
motion to achieve the best wash performance.
Water in the washer
does not drain or
drains slowly.
Drain hose is kinked, pinched, or clogged.
s or kinks and is not pinched behind or under
the washer.
The end of the drain hose is more than 96 inches (2.4 m) above the bottom of the
washer.
it is lower than 96 inches (2.4 m).
Bleach does not
dispense.
Bleach dispenser cover is not properly installed (on some models).
installed and snapped into place before the
beginning of the cycle.
Bleach dispenser is dirty or clogged.
debris that are collected inside the dispenser may prevent proper dispensing of the
bleach.
Premature
dispensing of bleach
Bleach dispenser filled for future load.
ture use. The bleach will be dispensed every
load.
Overfilling the bleach dispenser
bleach to dispense immediately, which will
damage the laundry or the washer. Always measure bleach, but never fill above the max
line on the dispenser. A half cup of bleach is sufficient for most loads. Never use more than
1 cup of bleach.
Problem Possible Cause & Solution