0 INSTALLATION INSTALLATION Before Installing Installation Overview Please read the following installation instructions first after purchasing this appliance or transporting it to another location.
INSTALLATION 11 Installation Location Requirements sides and rear, recommended clearances should be considered for the following reasons: ENGLISH Before installing the appliance, check the following requirements for the installation location. Installation Location tlet should be located within 2 ft. (61 cm) of either side of the appliance. slope under the appliance: 1°) of 1 inch (2.5 cm) under the appliance. If the slope is greater than 1 inch (2.5 cm), the appliance cannot be levelled properly.
12 INSTALLATION One example shown uses vent grilles in the door. a Upper vent opening with a minimum opening of 48 sq. in. (310 cm2) must be installed no lower than 6 ft. (185 cm) above the floor. Dimensions inch mm A 2 26 3/8 2 670 B 2 24 1/4 2 610 C 2 10 2 250 D 2 78 3/4 2 1999 E 2 78 1/4 2 1985 F 2 21 13/16 2 555 performance may be affected.
INSTALLATION 13 Unpacking the Appliance to unpack and move the appliance. Failure to do so can result in serious injury if the appliance tips or falls. Checking the Level Leveling the appliance prevents unnecessary noise, vibration and movement. Check whether the appliance is perfectly level after installation. WARNING Removing Carton and Shipping Materials required when leveling the appliance. Failure to follow this warning can cause serious injury or death.
14 INSTALLATION 3 When the appliance is completely stable and all leveling feet are resting solidly on the floor, tighten the locking nuts a. WARNING are designed to pierce through the carpet backing and pad and are very sharp. Installing on Carpeting spikes when setting the unit in place to avoid personal injury or product damage. Follow these instructions when installing the appliance on carpeting. WARNING necessary to install the rear leveling feet and carpet spikes.
INSTALLATION 15 Using Non-skid Pads Non-skid pads prevent the appliance from shaking or shifting when opening or closing the door. ENGLISH 1 Clean the floor to attach the non-skid pads. moisture. If moisture remains, the non-skid pads may slip. 2 3 Adjust the level after placing the appliance in the installation area. 3 To detach, pull one side out then the other. empty the water. After emptying it, reassemble the tray. Place the adhesive side a of the non-skid pads on the floor.
