Measurement Guide

Junction Box
Location
23 1/2”
Conduit
66 15/16”
30”
23”
5”
8”
28 1/2” Min.
28 5/8” Max.
23 1/2”
28 15/16” Min.
29” Max.
Minimum cutout
location from
oor 31”
Allow 1”
minimum for
overlap of oven
Allow 1”
minimum for
overlap of oven
Wall Ovens
IMPORTANT NOTES
PRODUCT DIMENSIONS
Single Built-In
Wall Ovens
QUICK INSTALL
& CLEARANCES
LSWS309BD
LSWS306ST
The rst step of the installation is
measure the current cutout dimensions
and compare them to the cutout
dimensions shown below. Little or no
cabinet work may be necessary
For full installation directions/clearances
please refer to the corresponding User
Manual and Installation Guide.
DIMENSIONS
Product (WxHxD) 29-3/4” x 29-5/16” x 24-3/8”
Cut-Out (WxHxD) 28-1/2” x 29” x 23 1/2”
Packing 33” x 30” x 57”
Net Weight / Gross Weight 157 lbs. / 179 lbs
Stufng Quantity (40 ft container) 84
POWER SOURCE
Rating 4.1kW
Electrical Supply 120/240 VAC, 120/208 VAC
Max Amp Load 17.3A
•
The cabinet base platform must be able to support 190lbs (86kg). If the cabinet
does not have a solid bottom, two braces or runners must be installed level with
the bottom of the cutout to support the weight of the oven. Make sure the base
is level and the front of the cabinet is square. If the cabinet base is not level, the
oven glides will tend to slide out when opening the door.
•
If marks, blemishes or the cutout opening are visible above the installed oven, it
may be necessary to add wood shims under the runners and front trim until the
marks or opening are covered.
•
If the cabinet does not have a front frame and the sides are less than 3/4” (1.9
cm) thick, shim both sides equally to establish the cutout width.
•
The junction box must be ush with the rear wall of the cabinet as shown below.
•
Allow at least a 23” clearance for the door depth when it is open.
•
Kitchen cabinets in contact with the oven must be heat resistant up to 194°F
(90°C), and fronts of nearby units up to at least 158°F (70°C).
27 3/8”
(69.5 cm)
29 5/16”
(74.5 cm)
w/o handle
24 1/2”
w handle
27”
29 3/4”
(75.5 cm)
23 3/8”
(59.3 cm)
28 7/8”
(73.3 cm)
CUTOUT DIMENSIONS
•
Cabinet Width 30” (762 mm)
•
Recommended
Minimum Cutout 31” (787.4 mm)
Location from Floor
•
Cutout Depth 23 1/2” Min. (596.9 mm)
•
Cutout Width 28 1/2” Min. (723.9 mm)
28 5/8” Max. (727 mm)
•
Cutout Height 28 15/16” Min. (735 mm)
29” Max. (736.6 mm)
LG Binder_STUDIO_Wall Ovens Fin_1.indd 2 8/1/17 8:51 AM