User's Manual

6. Mount SD Card(Optional)
Press and hold ‘Reset’ button more than 10 seconds until blink red of
Network LED
Reset Button 표현 그림 필요
9. Caution
1) This camera is an indoor good.(Don’t install outdoor)
2) Don’t cover vent hole
3) Don’t drop water or chemical substance.
4) Strong light is a cause of some image quality problem.
(sun light, headlight form automobiles, etc.)
Reset
5. Pairing the Device
4. Table-top installation
1. Attach the non-slip pad under mount bracket and lock the
camera body.
2. Adjust thecamera view direction
8. Factory Reset
LED
Status
Description
Camera Power LED
Blinking Green
Firmware updating
Pulsing Amber
Connecting to Server
Pulsing Green
Booting
Solid Amber
No Connectivity to Server
Solid Green
Working
Solid Red
Malfunction
Off
Power Off
Camera Network LED
Pulsing Green
Connecting to Router
Pulsing Red
No Connectivity to Router
Solid Green
Network Working
Solid Red
Network Working with weak
signal (RSSI < -80)
Off
Network Disabled
Camera Video LED
Solid Green
Recording
Off
Camera not Working
1. Plug in the camera.
2. Connect ethernet cable to controller ethernet port.
3. Please follow instructions on their controller.
Camera Video Led
7. LED Descriptioin
1. Insert a micro SD memory(be careful memory up/down side)
Camera Power Led
Camera Network Led