User manual

29
Trouble Shooting
Review this chart to find do-it-yourself solutions for minor performance problems.
Any service or repair needed, other than as described in this User’s Guide, should be performed through
your local LGE service center.
Electrical shock and personal injury hazard.
Always unplug the vacuum cleaner before servicing. Failure to do so could result in electrical shock or personal
injury.
WARNING
PROBLEM
Vacuum cleaner will
not run
Poor suction
Switch on, but hose LED
is on and alarm sound
“Dding~, Dding~”
Switch on, but unit LED is
on and alarm sound
“Dding Dding~, Dding
Dding~”
• Unplugged at wall outlet
• Hose is not connected to the
body properly
• Full or clogged dust tank and
filters
•
Dust tank improperly installed
• Clogged hose or wand
• Clogged nozzle
• Full or clogged dust tank and
filters
• Dust tank improperly installed
• Clogged hose or wand
• Clogged nozzle
• Dust tank is full
• Power is on without dust tank
• Rotating plate in the dust
tank is restricted because of
obstruction.
• Dust separator and filters is
full of dust.
• Power is on without dust
separator and filters.
POSSIBLE CAUSE
POSSIBLE SOLUTION
Indicatior
• Make sure cord is plugged into a
functioning outlet.
• Remove the hose from the body and
reconnect it properly. [See page 17]
• Empty dust tank and clean filters.
[See page 22 ~ 24]
• Make sure all dust tank components and
filters are installed correctly.
• Check for clogs. [See page 28]
• Empty dust tank and clean filters.
[See page 22 ~ 24]
• Make sure all dust tank components and
filters are installed correctly.
• Check for clogs. [See page 28]
• Empty dust tank
• Reattach dust tank
• Remove obstruction[See page 22 ~ 23]
• Clean dust separator and filters.
• Reattach dust separator and filters.
Indicatior