User guide

ManualsBrandsLG Electronics ManualsDVD PlayerV280B

Operation with tape

SHOWVIEW Programming

ShowView greatly simplifies entering the date, channel,

start and end times of a Timer Recording by simply

entering a ShowView Code. ShowView Codes are

published in most TV guide magazines; they can vary

one to nine numbers in length.

1. Make sure that TV channels have been tuned and

stored in correct

SHOWVIEW order.

Insert a video cassette with protection tab into your

DVD+VCR.

2. Press

SHOWVIEW.

3. Press the numbered buttons to enter the

ShowView Code of the TV programme that you

wish to record. If you make a mistake press

F then

enter the revised number.

4. Press ENTER/OK.

If PLEASE CHECK is displayed it means that you

have entered the wrong ShowView number, entered

the ShowView number incorrectly.

If “- -” is displayed, you have to enter the

programme number of the station, you want to

record from.

5. Press

F or G to select the settings that you wish to

revise. (PR, DATE, TIME, VPS and SP).

Press

D or E to enter the correct information.

6. Press G and press D or E to switch VPS/PDC

on or off. Press

G to select the recording speed.

Press

D or E to select the desired tape speed (SP,

IP, or LP).

IP mode determines how much tape is left and

switches speed from SP to LP, if necessary, to

complete recording the program.

IP mode is not selected when VPS/PDC is ON.

Check that the timer event details are correct.

If you wish to record from AUDIO IN and VIDEO IN

on the front or from either of the EURO SCART

sockets on the back of VCR, press AV to select for

correct display (AV1, AV2 or AV3).

7. If you want to make another ShowView recording

repeat stages 2 - 6. Press i twice.

If PLEASE CHECK is displayed, you have entered

incorrect information and will need to re-enter the

data.

Press POWER to switch your VCR power off mode.

Note:

The 1W Mode is not available in the standby

mode for the timer recording.

will appear in the video recorder’s display while

your VCR waits to make the recording.

To watch a DVD during timer recording standby

mode, press POWER and DVD to switch to DVD

mode.

8. Press POWER to end recording

Notes:

 Video Programme System (VPS)

The Video Programme System (VPS) ensures that

the TV programmes that you have programmed for

timer recording will be recorded exactly from their

beginning to end, even if the actual broadcasting time

differs from the scheduled time due to delayed start,

or if the programme is extended beyond its scheduled

time. Also, if a programme is interrupted, for example,

if a news flash is inserted, the recording will also be

interrupted automatically and resumed when the pro-

gramme continues.

The VPS signal is broadcast by the TV station and

this controls the timer in the video recorder.

VPS should be set ON for all timer recordings from

TV stations broadcasting these signals. It should be

set OFF for all timer recordings from TV stations that

are not broadcasting these signals.

*** The similar system PDC, which is used in the time

being in the Netherlands, can also be used with your

new video recorder.

0~9,

SHOWVIEW NO.

- - - - - - - - -

REC

0~9,

SHOWVIEW NO.

246876543

REC

DELETE :

PR DATE TIME

- - - -

- - - - - - - -~::

PR-01 12

11 11 55~::

PR DATE TIME

- - - -

- - - - - - - -~::

PR-01 12

11 11 55~::

PR DATE TIME

- - - -

- - - - - - - -~::

PR-01 12

11 11 55~::