User guide
Table Of Contents
- LICENSE
- SAFETY INSTRUCTIONS
- PREPARATION
- REMOTE CONTROL
- USING THE PROJECTOR
- ENTERTAINMENT
- SMARTSHARE
- MAGICAL MIRRORING
- CUSTOMIZING SETTINGS
- CONNECTING DEVICES
- INTERACTIVE FUNCTION
- To Connect the Interactive Pen to the PC
- Using The Interactive Pen
- Interactive Pen and Button
- Using the Interactive Pen Button
- To Charge the Interactive Pen
- Description of LED Interactive Pen Indicators
- To Replace the Pen tip
- How to Use the Strap
- To Clean Interactive Pen
- Operating Range with Interactive Pen
- To Use the Interactive Pen Functions
- Troubleshooting the Interactive Pen Function
- SERIAL COMMUNICATION FUNCTION
- MAINTENANCE
- WIRELESS SPECIFICATIONS
- SPECIFICATIONS
76
INTERACTIVE FUNCTION
WARNING
y
Do not replace or repair the battery yourself.
y
To charge the interactive pen, use the charging cable provided to connect the pen
to USB port of the PC.
To Charge the Interactive Pen
To charge the battery, connect the interactive pen to the PC with the charging cable.
(Check that the PC is turned on before connection.)
The battery light stays on during charging and will turn off when charging is complete.
When charging is complete, disconnect the charging cable in order to use the pen. Alternatively,
use the interactive pen while connected by the charging cable if charging is not complete.
y
Warning message (low battery)
- When the battery voltage is 3.6 V or
lower, the low battery warning message
is displayed. The interactive pen will
work for about 10 minute after this
message is displayed.
- The interactive pen may not work
when the battery level is 3.4 V or lower.
y
When you use the pen for the first time,
charge the battery for at least 3 hours.
The fully charged battery lasts 20 hours
when it is continuously used, or four
weeks in standby mode.
(For SA565 only)