User guide

73
INTERACTIVE FUNCTION
INTERACTIVE FUNCTION
To Connect the Interactive Pen to the PC
Connect the USB A to B cable from the projector's USB 1 (INTERACTIVE/SVC) port
and a PC USB port.
CAUTION
y
Up to two pens can be used at the same time.
y
Pairing is not available when one of the paired pens is in use.
y
In the Fixed Pairing mode, up to 10 pens can be paired one at a time.
y
You must install the WizTeach program in the CD provided with the accessories
on your PC before using the Annotation Software. The product key required to
install the WizTeach program is attached to the back of the enclosed WizTeach
software CD case. Make sure that you do not lose the product key.
y
If the interactive pen is not used for more than 30 seconds, it will switch to low
power mode. Press any button to return the pen to normal mode.
y
Use the remote control within the specified range (see Operating Range with
Interactive Pen). You may experience communication failures when using the
device outside the coverage area or if there are obstacles within the coverage area.
y
You may experience communication failures depending on the accessories. Devices
such as a microwave oven and wireless LAN operate in the same frequency band
(2.4 GHz) as the interactive pen. This may cause communication failures.
y
Make sure not to block the image when using the interactive pen.
Connect the interactive dongle to the projector's INTERACTIVE port.
(For SA565 only)
Pairing