User guide

Connect the appropriate power cables to a monitor and NC1000 respectively.

NC1000

Connecting a Monitor with D-sub Cable

In/Out Cable Connection

In order to watch video on a monitor, you need to use a D-sub cable or an HDMI cable to connect the

NC1000 to a monitor.

Attention

● D-sub, HDMI, LINE-OUT, OPTICAL, and LAN cables are not included with the NC1000. If the cables were

not provided with your monitor, you may need to purchase them separately.

● After cabling is complete, assign the SET ID of the monitor to be connected to NC1000.

● To configure the SET ID, please refer to the owner’s manual for your monitor.

Attention

● A D-sub cable connection does not include an audio signal. For audio, you need to connect a LINE-OUT

or OPTICAL cable.

● D-sub cables are also known as RGB cables.

When using the SuperSign Manager software:

● The monitor SET ID is a unique number used to identify the monitor. You can choose a number from 1 to

25. The SET ID allows the SuperSign Manager software to identify the monitor.

● In order to directly connect the monitor to NC1000, its SET ID must be set to 1.

● To use SuperSign Manager, the monitor that will be connected to NC1000 must support the LG RS232C

protocol. A monitor supporting the LG RS232C protocol can control the monitor functions, such as bright-

ness and sound, using SuperSign Manager.

Note

NC1000