User guide

9
1 Connect the appropriate power cables to a monitor and NC1000 respectively.
NC1000
Connecting a Monitor with D-sub Cable
In/Out Cable Connection
In order to watch video on a monitor, you need to use a D-sub cable or an HDMI cable to connect the
NC1000 to a monitor.
Attention
● D-sub, HDMI, LINE-OUT, OPTICAL, and LAN cables are not included with the NC1000. If the cables were
not provided with your monitor, you may need to purchase them separately.
● After all required cables are connected, configure SET ID to 1 for the first monitor connected to the
NC1000. The SET ID for one of the connected monitors should be configured to 1.
● To configure the SET ID, please refer to the owner’s manual for your monitor.
● Monitors used with NC1000 should support LG RS-232C protocols. The brightness, resolution, sound, and
other features of an LG RS-232C protocol-enabled monitor can be controlled by SuperSign Manager soft-
ware.
Attention
● A D-sub cable connection does not include an audio signal. For audio, you need to connect a LINE-OUT
or OPTICAL cable.
● A SET ID is a reference number for the monitor that can be set to the user's preference. The monitor
SET ID is used by the SuperSign Manager software to identify monitors.
Note
● D-sub cables are also known as RGB cables.
Note
NC1000