User guide

52
Cannot play MP3/WMA/JPEG/DivX files.
• The files are not recorded in a format that the unit can play.
• The unit does not support the codec of the DivX movie file.
• The resolution is higher than the unit can support.
Recording
Cannot record or does not record successfully.
• Check the remaining space on the disc.
• Check that the source you are trying to record in not copy protected.
• The power may have failed during recording.
• Use a VR mode formatted disc for copy-once material.
Timer record does not record successfully.
• Clock is not set to correct time.
• The start time of the timer recording is past.
• Two timer recordings may have overlapped, in which case only the earlierone will record completely.
• When setting the recording channel, make sure you set the unit’s built-in tuner, not the TV’s built-in tuner.
Stereo Audio Record and/or Playback is not present.
• TV is not Stereo-compatible.
• Broadcast program is not in stereo format.
• The A/V Output jacks on the unit are not connected to TV A/V In jacks.
HDMI
The connected HDMI device does not display any picture.
• Try disconnecting then reconnecting the HDMI cable.
• Try switching the power of the HDMI device off then back on.
• The video input of the connected device is set correctly for this unit.
• The HDMI cable you are using is fully HDMI-compliant. Using a non-standard cable may result in no picture
being output.
• Not all HDCP-compatible DVI devices will work with this unit.
The connected HDMI device does not output sounds.
• Some HDMI-compatible devices do not output sounds (check the manual that came with the connected
device).
• If your TV is not capable of handling 96 kHz sampling frequency, set the [Sampling Freq.] option to [48 kHz]
on the setup menu. When this choice is made, this unit will automatically convert any 96 kHz signals to 48
kHz so your system can decode them.
• If your TV is not equipped with Dolby Digital and MPEG decoder, set the [Dolby Digital] and [MPEG] options
to [PCM] on the setup menu.
• If your TV is not equipped with DTS decoder, set the [DTS] options to [OFF] on the setup menu. To enjoy
DTS multi channel surround, you must connect this unit to a DTS compatible receiver via one of this unit’s
digital audio outputs.
Resetting the unit
If you observe any of the following symptoms.
• The unit is plugged in, but the power will not turn on or off.
• The front panel display is not working.
• The unit is not operating normally.
You can reset the unit as follows.
• Press and hold the POWER button for at least five seconds. This will force the unit to power off then turn the
unit back on.
• Unplug the power cord, wait at least five seconds, and then plug it in again.