User guide
48
Due to the considerable quantity of different code numbers, up to 350 different codes are pre-programmed per
device type. In individual cases it may be possible that only the most common main functions are available. The
process described here may not work for some special models.
Automatic search
If your device does not respond to the remote control, even though you have tried all of the codes listed for your
device type and the relevant brand, then try using the automatic search. This will enable you to find codes for
brands that were not listed in the device Code List.
Switch the relevant device on manually.
Keep the
CODE
key pressed for approx. 3 seconds until the blue LED remains solid.
Briefly press the required souce key (TV, STB, VCR, AUX).
Point the remote control at the device and briefly press the button
P+
once.
If the device has no program function, press
P+
or
POWER
instead.
The remote control starts the code search after 6 seconds and transmits all codes consecutively at 1-second
intervals (see also next section). The source key will light up for each transmission.
As soon as the device responds to the remote control, press
OK
.
If you did not press
OK
at the right time, you can return to the code to which the device responded step by
step by pressing
P–
key.
To cancel the search, press
EXIT
.
1 second or 3 second intervals
If you want the remote control to transmit a new code every 3 seconds instead of every second, proceed as
follows:
Within 6 seconds of pressing the
P+
(or
POWER
) key as described in Point 4 press the
P+
or
P–
key again.
The remote control will now only transmit a new code every 3 seconds. This gives you more time, but the
procedure will also take longer.
Code searching by brand name
This function gives you the option of searching by brand name (see code list). This is done as follows:
Switch the relevant device on manually.
Keep the
CODE
key pressed down for approx. 3 seconds until the background lighting of the source key
briefly flashes and then remains on.
Briefly press the required source key (TV, STB, VCR, AUX).
Enter the one-digit code according to the following table:
Key 1 = Medion, Tchibo
Key 2 = Philips, Radiola, Philco, Erres, Pye
Taste 3 = Sony, Akai, Panasonic, JVC, Sharp, Toshiba, Daewo
Key 4 = Thomson, Brandt, Fergusson
Key 5 = Saba, Nordmende, Telefunken
Key 6 = Grundig, Blaupunkt
Key 0 = all brands.
Continue pressing the
P+
key (or for video recorders
POWER
or
PLAY
), until the device responds
accordingly. Proceed quickly, otherwise the automatic code search will start.
Save the code by pressing
OK
.
If all the codes have been searched, the source key will flash for approx. 3 seconds.
Code identification
Code identification gives you the opportunity to determine codes that have already been entered and stored in
the remote control. Proceed as follows:
Switch the relevant device on manually.
Keep the
CODE
key pressed for approx. 3 seconds until the blue LED remains solid.
Briefly press the required source key (TV, STB, VCR, AUX).
Briefly press the
CODE
button. The source key will briefly extinguish after the key has been pressed.