Troubleshooting Guide

68 TROUBLESHOOTING
Oven light does not
work.
It is time to replace the lamp or the lamp is not tightened enough.
The plug on the range is not completely inserted in the electrical outlet.
Oven will not Self
Clean. (On some
models)
The oven temperature is too high to set a Self Clean operation.
Oven controls improperly set.
A Self Clean cycle cannot be started if the oven Control Lock feature is active.
Oven door does not
open after a Self
Clean cycle (On some
models)
Oven is too hot.
The control and door may be locked.
ter the completion of a Self Clean cycle. The
door can be opened when the lock
k
is no longer displayed.
The oven is not clean
after a Self Clean
cycle (On some
models)
Oven controls not properly set.
Oven was heavily soiled.
clean cycle. Heavily soiled ovens may need to
Self Clean again or for a longer period of time.
CLEAN and door
flash in the display
(On some models)
The Self Clean cycle has been selected, but the door is not closed.
"Loc" is on in the
display when you
want to cook (On
some models)
The oven is locked because of the Control Lock feature.
Oven control beeps
and displays any F
code error.
Electronic control has detected a fault condition.
nutes and then reconnect the power. If the
function error code repeats, call for service.
oven gas shut-off valve and call for service.
The oven racks were
cleaned in a Self
Clean cycle. (On
some models)
The shiny, silver-colored racks were cleaned in a Self Clean cycle.
paper towel and wipe the edges of the oven
racks with the paper towel. Do not use lubricant sprays.
Displayed colon in
the clock is flashing
This means that the product has just been plugged in, or that it has experienced a
power interruption.
Light can be seen
through the oven air
vents.
While the Broil function is running, it is normal to see a light between the oven air
vents.
Problem Possible Cause & Solution