User manual

Owner's Manual 25
Operating Instructions
Twin Temperature Logic
1.
Helpful information
Fan speed and cooling capacity.
The cooling capacity indicated in the specification is the value when the fan speed is set to high, and the
capacity will be lower at low or medium fan speed.
High fan speed is recommended when you wish to cool the room quickly.
Forced operation
Heat pump Model
Cooling Model
Room Temp. ³ 24°C 21°C ³ Room Temp. < 24°C Room Temp. < 21°C
Operating mode Cooling Cooling Healthy Dehumidification Heating
Indoor FAN Speed High High High High
Setting Temperature 22°C
Test operation
During the TEST OPERATION, the unit operates in cooling mode at high speed fan, regardless of room
temperature and unit will stop after18 minutes.
During test operation, if remote controller signal is received, the unit operates as remote controller sets.
If you want to use this operation, Press and hold the ON/OFF button for 3~5 seconds, then the buzzer sound
1 "beep".
If you want to stop the operation, re-press the button.
22°C 23°C 24°C
If you want to stop the unit, re-press the power button.
Turn ON the unit using power button.
Turn OFF the unit using power button.
Switch OFF the mains supply to the unit.
Switch ON the mains supply to the unit.
Turn ON the unit using the power button.
After turning ON the unit will operate
according to the table below :
Please follow the step 1 to step 5
for forced operation.
1.
2.
3.
4.
5.
Note : Forced operation button location varies with model.
Display on Indoor Unit shows the desired set Temperature for 5 seconds and then automatically shifts to the
Room Temperature.
2. Pressing any key (except Room/Power) Display will show Set Temperature for 5 sec and then automatically
shifts to the Room Temperature.
3. Room Temperature on Display and Remote might be different.
Open the front
panel upward
Power
button