K M Room Air Conditioner (Single Split Wall Mounted Type) OWNER'S MANUAL Before using your air conditioner please read this manual carefully and keep it for future reference. Prior to installation, this air-conditioning unit must be submitted for approval by the utility service which provides electricity (EN 60555-3 Norm).
Safety Precautions Safety Precautions Installation Precautions ......3 FOR YOUR RECORDS Operation Precautions .......4 Write the model and serial numbers here for the indoor and outdoor units: Indoor model # Serial # Outdoor model # Serial # You can find them on a label on the side of each unit. Dealer's Name Troubleshooting Tips Care and Maintenance Operating Instructions Date Purchased Operating Instructions Remote Control Features...7 Operation Mode Selection ..
To prevent injury to the user or other people and property damage, the following instructions must be followed. ■ Incorrect operation due to ignoring of instruction will cause harm or damage, the seriousness is classified by the following indications. WARNING : This symbol indicates the possibility of death or serious injury. CAUTION : This symbol indicates the possibility of injury or damage to properties only. Be sure not to do. Be sure to follow the instruction.
Safety Precautions Operating Instructions Care and Maintenance Troubleshooting Tips Operation precautions WARNING Plug in the power plug properly. Do not operate or stop the unit by inserting or pulling out the power plug. • Otherwise, it will cause electrical shock or fire due to heat generation. • It will cause electrical shock or fire due to heat generation. • It will cause electrical shock or fire.
Safety Precautions Operating Instructions Care and maintenance Troubleshooting Tips 5
Safety Precautions WARNING When the unit is not going to be used for a long time, turn off the circuit breaker. • If not, dirt may collect and cause a fire. Do not operate for a long time in high humidity, e.g. leaving a door or window open. • In the cooling mode, if it is operated in a room with high humidity (80%RH or more) for a long time, water condensed in the air conditioner may drop and may wet and spoil furniture, etc. Do not step on the indoor/outdoor unit and do not put anything on it.
About the remote control on the system Features of the Remote Control- Door Open Signal transmitter 1 CHAOS TIME a.m. p.m. OFF TIME a.m. p.m. Hr. 2 Heat pump model Cooling model 3 ON OFF 4 8 5 9 SET CANCEL 10 6 7 11 Operating Instructions ON Safety Precautions The remote control transmits the signals to the system. RESET 1 2 3 OPERATION DISPLAY 7 Displays the operation conditions. Used to stop or start louver movement and set the desired up/down airflow direction.
Safety Precautions Features of the Remote Control- Door Closed CHAOS ON Operating Instructions a.m. p.m. TIME OFF TIME a.m. p.m. Hr. 1 2 Heat pump model Cooling model 3 4 Care and Maintenance Flip-up door(closed) 1 2 START/STOP BUTTON 3 Operation starts when this button is pressed and stops when the button is pressed again. Used to select the room temperature.
About the remote control on the system • To operate the room air conditioner, aim the remote control at the signal receptor. • The remote control will operate the air conditioner at a distance of up to 7m. • The remote control may be stored inside the system or mounted on a wall. How to Insert the Batteries NOTES: • Use 2 AAA(1.5volt) batteries. Do not use rechargeable batteries. • Remove the batteries from the remote control if the system is not going to be used for a long time.
Safety Precautions Operating Instructions Care and Maintenance Troubleshooting Tips How to use the Operation Mode Selection button Cooling Operation 1 Press the Start/Stop button. The unit will respond with a beep. 2 Open the door on the remote control. To select Cooling operation, press the Operation Mode Selection button. Each time the button is pressed, the operation mode is shifted in the direction of the arrow.
1 Open the door on the remote control. To select Soft Dry operation, press the Operation Mode Selection button. Each time the button is pressed, the operation mode is shifted in the direction of the arrow. Cooling Auto Heating (Heat pump model only) Close the door on the remote control. Set the temperature lower than the room temperature. The temperature can be set within a range of 18°C~30°C in 1°C increments.
Safety Precautions Operating Instructions Auto Operation 1 2 Press the Start/Stop button. The unit will respond with a beep. Open the door on the remote control. To select Auto operation, press the Operation Mode Selection button. Each time the button is pressed, the operation mode is shifted in the direction of the arrow.
Press the Start/Stop button. The unit will respond with a beep. 2 Open the door on the remote control. To select Heating operation, press the Operation Mode Selection button. Each time the button is pressed, the operation mode is shifted in the direction of the arrow. Cooling Auto Heating (Heat pump model only) Close the door on the remote control. Set the temperature higher than the room temperature. The temperature can be set within a range of 16°C~30°C in 1°C increments.
Safety Precautions Operating Instructions Additional features Sleep Mode To cancel the Sleep Mode, press the sleep Mode Auto button several times until the star ( ) disappears from the operation display. Press the Sleep Mode Auto button to set the time you want the unit to turn off automatically. The Timer is programmed in one-hour increments by pressing the Sleep Mode Auto button 1 to 7 times. The sleep mode is available for 1 to 7 times.
The up/down airflow (Vertical Airflow) can be adjusted by using the remote control. NOTE: ❏ Always use the remote control to adjust the up/down airflow direction. Manually moving the vertical airflow direction louver by hand could damage the air conditioner. ❏ When the unit is shut off, the up/down airflow direction louver will close the air outlet vent of the system. 1 2 Press the Start/Stop button to start the unit. Open the door on the remote control.
Safety Precautions Operating Instructions FORCED OPERATION Operation procedures when the remote control can't be used. Open the front panel upward and move the Slide Switch to the Forced Operation position. If you want to stop operation, move the Slide Switch to the Auto Restart or the Remote Control position. In case the power comes on again after power failure on the Forced Operation position, the operating conditions are automatically set as follows: During Forced Operation, the initial mode continues.
Soft Dry Operation Mode (Refer to page 11) When the room temperature is higher than the set temperature, it operates in cooling mode at the set temperature, the set fan speed (if CHAOS mode, then medium.), and then it will be in automatically switched to Soft Dry Mode when the room temperature reaches the set temperature. In Soft Dry Operation, the indoor fan speed is automatically switched to the low. ROOM TEMP. COOLING ROOM TEMP. Operating Instructions SET TEMP. +1°C SOFT DRY SET TEMP. -0.
Safety Precautions Operating Instructions Care and maintenance of the air conditioner CAUTION: Before performing any maintenance, turn off the main power to the system. Indoor Unit Grille, Case, and Remote Control ❏ Never use any of the followings: ❏ Turn the system off before cleaning. To clean, wipe with a soft, dry cloth. do not use bleach or abrasives. NOTE: Supply power must be disconnected before cleaning the indoor unit. • Water hotter than 40°C Could cause deformation and/or discoloration.
When air conditioner is not going to be used for a long time. When the air conditioner is to be used again. Clean the air filter and re-install it in the indoor unit. (Refer to page 18 for cleaning filters.) Operate the air conditioner on Air circulation mode (Reter to page 15) for 2 to 3 hours. • This will dry out the internal parts. Turn off the circuit breaker, and disconnect the plug. Check that the air inlet and outlet of the indoor/outdoor unit are not blocked.
Safety Precautions Operating Instructions Do not overcool the room. Keep blinds or curtains closed. Keep the room temperature uniform. This is not good for your health and wastes electricity. Do not let direct sunshine enter the room when the air conditioner is in operation. Adjust the vertical and horizontal airflow direction to ensure a uniform temperature in the room. Make sure that the doors and windows are shut tight. Clean the air filter regularly. Ventilate the room occasionally.
Before you call for service... Troubleshooting Tips! Save time and money! Check the following points before requesting repairs or service.... If the fault persists, please contact your dealer or service center. Does not operate. It seems that condensation is leaking from the air conditioner. • Condensation occurs when the airflow from the air conditioner cools the warm room air. • Check that this is not a damp smell exuded by the walls, carpet, furniture, or cloth items in the room.
P/NO.
