Full Product Manual

13INSTALLATION

ENGLISH

Preparing Cabinet Opening

This dishwasher is designed to fit a standard

dishwasher opening. An opening may be needed

on both sides to route plumbing and electrical

connections.

• To ensure proper drainage, install the dishwasher

no more than 12 ft. (3.65 m) from the sink.

• The location must have sufficient space for the

dishwasher door to open easily and provide at

least 0.1” (2 mm) between the dishwasher and the

cabinet sides.

• If installing the dishwasher in a corner, leave a

minimum of 2” (50 mm) between the dishwasher

and the adjacent wall.

• The adjacent wall must be free of obstructions.

• For flush installations only, you may remove the

cabinet brace inside the cabinet.

Select a location as close to the sink as

possible for easy connections to water supply

line, drain hose and electrical connection.

To allow for proper clearance of plumbing and

electrical, use the template included with the

literature to determine the clearance on the

side of the cabinet where the cabinet meets

the back wall. Using a 2

/2” diameter hole saw,

drill a hole in the target area as shown on the

template.

3.5

2.5

WARNING

• Installation damage is not covered by the

warranty, and leaks caused by improper

installation may result in property damage.

• Do not use existing holes unless they are in the

target area.

• Failure to properly locate the hole for the water

and drain lines may prevent the dishwasher

from installing flush with the cabinets and could

result in kinked, pinched, crushed, stressed or

damaged lines.