User guide

Connecting
16
Connecting
2
4. Select an item using
W/S
. If you know the
programmed [LNB Frequency], [22kHz Tone],
[DiSEqC], [LNB Power], [Transponder] and
[Motor], use
A/D
to select the desired.
If you select [DiSEqC 1.2], you can set Motor
Driving Mode, Motor Move and Set Limit,
and if you select [USALS], you can set the
longitude and latitude and use
S
to select
[Go to position]; then motor will move to your
selelected satellite as calculating its position.
If you use USALS, you should know lines of
longitude and latitude at your location.
,
Note
5. Use
W/S
to select the [Save] and press ENTER
(
b
) to display the [Saved List] menu.
If there isn’t LNB Frequency what you want in
[LNB Frequency], input LNB Frequency with
numerical buttons.
,
Note
6. Use
W/S/A/D
to select the [Go To Tuning]
and press ENTER (
b
).
7. Select [Start] and press ENTER (
b
) to begin the
channel search.
Use
W/S
to select a satellite check box and
press ENTER (
b
) to select or deselect it.
You can search All, FREE, CAS channels
individually. Press
W
, you can select Search Type
with
A/D
.
[All]
All channels the satellite searches.
[FREE]
Free of charge channels.
[CAS](Conditional Access System)
Pay channels.
Select [Stop] and press ENTER (
b
) to stop the
channel search.
8. Press ENTER ( ).
Please refer to the manuals of your TV, Stereo
System or other devices as necessary to make
the best connections.
,
Note
Auto Tuning
All available satellite TV or radio programmes are
searched.
1. Use
W/S
to select the [Auto Tuning] and
press ENTER (
b
).
2. Follow the steps 7-8 from “Antenna Setting” on
page 15-16.