User's Manual

900MHz DSST PHONE with CALLER ID, SPK PHONE and ANSWERING SYSTEM.
5. Replace the battery door.
STEP 5. TURN THE HANDSET ON
You
MUST
i nstall the battery o n the handse t to turn on and use your p ho ne.
1. Check the power is on and appears on the display
2. You'll hear the handset's ready tones
and the 'READY' message appears on the display.
STEP 6. CHARGE THE HANDSET
Before you use the phone for the first time, you need to charge the battery
for at least 6 hours.
Place the handset in the base of the phone. The charge light the base then comes on.
Whenever you need to charge your handset, you hear short beeps and see the 'LOW BATTERY'
message. Press
TALK
and listen for dial tone to test for a fully charged handset.
STEP 7. Beginning the programming Sequence
Most of the programming options appear in one screens.
Press
PGM
key, SETUP PROGRAM appears on the screen.
1. Press down on the battery cover and slide
the battery cover down to expose the
battery well.
2. Locate the battery connectors inside the
battery well.
If you are replacing a dead battery, remove
the old battery by pulling firmly on the
battery cords.
3. Insert the battery plug into the connector.
It is polarized and only insert in one
direction.
4. Place the battery in the battery well.
READY
SETUP PROGRAM