User's Manual

900MHz DSST PHONE with CALLER ID, SPK PHONE and ANSWERING SYSTEM.
4. Turn the mounting bracket around so that the larger part the wedge is set the bottom of the phone
5. Use the same method to replace the bracket.
6. Insert the 8 inch line cord into phone jack marked TEL Line.
7. Thread the line cord through the channel on the right-hand side of the bracket to secure the cord.
8. Plug the adapter tip into the adapter jack.
Be sure that the tip is all the way into the jack.
9. Thread the adapter cord through the channel on the left-hand side of the bracket.
10. Insert the other end of the line cord into the wall jack.
11. Align the holes in the bracket over the wall-plate posts.
12. Slide the phone down until the phone is secure.
STEP 3. PLUG IN THE ADAPTER
Plug the adapter into an electrical outlet. Without AC power, your phone does not operate.
STEP 4. ADD THE BATTERY TO THE HANDSET
Use this procedure to install or to replace a "dead" battery.


!
!!
!
C
AUTION
Use only nickel-cadium(Ni-Cad)battery in the phone.