User guide

2
Important Safety Instructions
General
Before you use this device for the first time, please
read the following notes in this manual and heed all
warnings, even if you are familiar with handling
electronic devices. Keep this manual in a safe place
for future reference. If you sell or pass this device on
to another person, it is imperative that you also hand
over this manual.
Condiciones ambientales
• Position the device on a stable, even surface and do
not place any heavy objects on the device.
• The device is not for use in environments with a
high temperature or humidity (e.g. bathrooms), and
must be kept free of dust
• Operating temperature and humidity: 5 °C to 35 °C,
max. 85 % RH
• Always make sure that
• there is free circulation of air (do not place the
device on shelves, on a thick carpet, on a bed, or
anywhere that obstructs the ventilation slots, and
leave at least 10cm clearance on all sides;
• no direct heat sources (e.g. heating) can affect the
device;
• no direct sunlight or bright artificial light reaches
the device;
• contact with spray and dripping water and
abrasive liquids must be avoided and the device
should never be operated near water, and it must
especially never be immersed (do no place any
objects filled with liquids such as vases or drinks
near the device);
• never place the device in the immediate vicinity of
magnetic fields (e.g. loudspeakers);
• do not place any fire sources (e.g. burning
candles) on or near the device;
• do not introduce any foreign bodies into the
device;
• the device must not be subject to any great
temperature changes as this may cause moisture
through condensation and shortcircuit;
• the device should not be subject to excessive
shocks and vibrations;
Power Supply
• The power switch of this device does not fully
disconnect the device from the mains.
• The device consumes electricity in the Standby
mode. In order to completely disconnect the device
from the mains, the power plug must be pulled out
from the wall outlet. For this reason, the device
should be positioned in a way that assures a direct
and unobstructed access to the wall outlet so that
the power plug can be immediately pulled out in an
emergency situation. To avoid the danger of fire if
the device is not going to be used for a long while
(e.g. during holidays), it should always be
disconnected from the power socket. Before stormy
weather when there is the danger of lightning,
disconnect the device from the power supply.
• Insert the batteries with the correct polarity and
never try to recharge the batteries and under no
circumstances throw them into fire. Do not mix
batteries (old and new or carbon and alkaline, etc.).
Remove batteries when the device is not to be used
for a long time. Non-intended use may cause
explosion and danger to life.
• Respect the environment! Old batteries do not
belong in with the domestic waste! They must be
handed in to a collection point for old batteries.
Cables
• Always hold cables by the plug and never pull on
the cable itself.
• Never hold the power cord with wet hands as this
may cause a short circuit or electric shock.
• Never place the device, heavy objects or furniture
on the cable and take care that the cord does not
become trapped, especially at the plug and sockets.
Never make knots in the cable and do not tie it
together with other cords. All cables should be
positioned so that nobody can trip over them or be
obstructed by them.
• A damaged power cord can cause a fire or an
electric shock. Inspect the power cord from time to
time. Never use adapter plugs or extension cables
that don’t comply with the current safety regulations
in your country, and don’t modify any of the power
cords or electrical installations yourself!