User guide

20
ENG
ENGLISH
TROUBLESHOOTING
Displayimageisincorrect
Doesthedisplaycolorappear
discolored(16color)?


Setthecolorto24bit(truecolor)orhigher.InWindows,gotoControlPanel>
Display>Settings>ColorQuality.
Thescreencolorismonoor
abnormal.


Checkifthesignalcableisproperlyconnectedanduseascrewdriverto
fastenifnecessary.


Makesurethevideocardisproperlyinsertedintheslot.


Setthecolorsettinghigherthan24bits(truecolor)atControlPanel►
Settings.
Thescreenblinks. 

Checkifthescreenissettointerlacemodeandifyes,changeittothe
recommendresolution.
Doyouseean"Unrecognizedmonitor,Plug&Play(VESADDC)monitorfound"message?
Haveyouinstalledthedisplay
driver?


BesuretoinstallthedisplaydriverfromthedisplaydriverCD(ordiskette)that
comeswithyourdisplay.Or,youcanalsodownloadthedriverfromourweb
site:http://www.lg.com.


MakesuretocheckifthevideocardsupportsPlug&Playfunction.
TROUBLESHOOTINGWHENUSING3DMODE
Imagesdisplayedarenotin3D.
Ifyouview3Dimagesoutsidethe
optimalviewingangleordistance,


Theoptimalviewingangleforthismonitorisverticallyup30°,verticallydown
10°andhorizontal±25°;theoptimalviewingdistanceisbetween70cmto
80cm(max.distance:70cmto110cm)fromthemonitor.Whenyouview
3Dimagesoutsidetheoptimalviewingangleorviewingdistance,theimages
mightappearoverlappedornotbedisplayedproperlyin3D.
Ifyouhavenotsettheresolution, 

Pleasesettheresolutionofthemonitortothemaximum(1920x1080@
60Hz)inthedisplaysettings.The3Dsoftwaremaynotworkproperlyifthe
resolutionisnotsettothemaximum.
Ifleft/rightimagesarereversed 

Sometimes,left/rightimagesfromthe3Dcontentinputarereversed.Change
theleft/rightimagesequenceintheplayerorviewersettingsofthe3D
software.(RefertotheInstallationManualfor3DViewing.)
Ifambientbrightnessislow 

Auser'sfacemustbedetectedthroughthecameraattachedtothefrontofthe
monitorfrontinordertoenable3D.


Increasetheambientbrightnessforthecameradisplaytodetecttheface.
Ifthecameradisplayforfacial
recognitionisnotshown


ChecktheUSBcableconnection.Ifitisproperlyconnected,changetheUSB
portandreconnect.


CarryoutthefollowingifyouseethemessagesbelowinthePC:
"ThisDeviceCanPerformFaster"(Windows7)
"HI-SPEEDUSBDeviceAttachedToNon-HI-SPEEDHub"(WindowsXP)

»
Troubleshooting
1.ChangetheUSBportbeforepluggingin.
2.UsearearUSBport,ratherthanafrontUSBport,forthedesktop
computer.
Miscellaneous 

Ifyouseedoubledimagesorshakyimages,re-runtheTriDef3Dcalibration
programtoadjust3Dimages.(RefertotheInstallationManualfor3DViewing.)