User guide

Operating 19
Operating
3

On some speakers, sound may not be heard
or heard in low sound depending on the
sound mode.

Maybe you need to reset the surround
mode, after switching the input, sometimes
even after the sound track changed.

By pressing BASS BLAST on the unit you
can directly select the BYPASS or BASS
BLAST sound.
,
Note
Setting the Clock
1. Turn the unit on.
2. Press CLOCK.
3. Choose time mode by pressing
Y/U
.
- AM 12:00 (for an AM and PM display)
or 0:00 (for a 24 hour display)
4. Press SET/DEMO/RDS to confirm your
selection.
5. Select the hours by pressing
Y/U
.
6. Press SET/DEMO/RDS.
7. Select the minutes by pressing
Y/U
.
8. Press SET/DEMO/RDS.
9. If you want to reset the clock, press and hlod
CLOCK. Then repeat steps 2-8.
Setting the alarm
You can use the unit as an alarm clock.
You have to set the clock before setting the alarm.
1. Turn the unit on.
2. Press TIMER.
3. Each of functions will blink. Press SET/DEMO/
RDS to select a sound source you want.
4. “ON TIME” will be displayed. This is your desired
time to the unit turns on. Press
Y/U
to
change the hours and minutes and press
SET/DEMO/RDS to save.
5. The “OFF TIME” will be displayed. This is your
desired time to the unit turns off. Press
Y/U
to change the hours and minutes and press SET/
DEMO/RDS to save.
6. Press
Y/U
to change the volume and
press SET/DEMO/RDS to save. The clock icon
"
(
“ shows that the alarm is set.
7. Press TIMER. You can check the setting status.
8. If you want to reset the alarm, press and hlod
TIMER. Then repeat steps 3-6.
CM4230_DU.DDEULLK ENG 0439.indd 19CM4230_DU.DDEULLK ENG 0439.indd 19 2013-03-20  2:05:182013-03-20  2:05:18