ENGLISH РУССКИЙ ЯЗЫК O‘ZBEK TILI OWNER’S MANUAL AIR CONDITIONER Please read this manual carefully before operating your set and retain it for future reference. The equipment complies with requirements of the Technical Regulation, in terms of restrictions for the use of certain dangerous substances in electrical and electronic equipment. www.lg.
Room Air Conditioner Owner’s Manual TABLE OF CONTENTS A. Safety Precautions ..............................3 B. Electrical Safety...................................6 Temporary Use of an Adapter ...............6 Temporary Use of an Extension Cord ...6 Symbols used in this Manual.................6 C. Product Introduction...........................7 Indoor Units ...........................................7 Operation Indication Lamps ..................8 Outdoor Unit ..........................................
Safety Precautions To prevent injury to the user or other people and property damage, the following instructions must be followed. n Incorrect operation due to ignoring instruction will cause harm or damage. The seriousness is classified by the following indications. This symbol indicates the possibility of death or serious injury. This symbol indicates the possibility of injury or damage. n Meanings of symbols used in this manual are as shown below. Be sure not to do. Be sure to follow the instruction.
Safety Precautions Indoor/outdoor wiring connections must be secured tightly and the cable should be routed properly so that there is no force pulling the cable from the connection terminals. Safely dispose off the packing materials. Like screws, nails, batteries, broken things etc after installation or svc and then tear away and thraw away the plastic packaging bags. Make sure to check that the power cable plug is not dirty, loose or broken and then only insert the plug completely.
Safety Precautions • There is risk of damage or loss of property. Do not touch the metal parts of the product when removing the air filter. • There is risk of personal injury. Do not insert hands or other objects through the air inlet or outlet while the product is operating. • There are sharp and moving parts that could cause personal injury. Do not tilt the unit when removing or uninstalling it. • The condensed water inside can spill .
Electrical Safety Electrical Safety • This appliance must be properly grounded. To minimize the risk of electric shock, you must alway plug into a grounded oulet. • Do not cut or remove the grounding prong from the power plug. • Attaching the adapter ground terminal to the wall receptacle cover screw does not ground the appliance unless the cover screw is metal and not insulated, and the wall receptacle is grounded through the house wiring.
Product Introduction Here is a brief introduction of the indoor and outdoor units. Please see the information specific to your indoor unit type.
Product Introduction Art Cool Deluxe(Type 1) Display panel LED indicators Art Cool Deluxe(Type 2) Display panel LCD indicators Air inlet Air filter Plasma filter Air filter Air discharge Power cord Plasma filter Front panel Signal receiver Air discharge Front panel Air inlet Air inlet Air filter Plasma filter Signal receiver Art Cool Deluxe(Type 3) Display panel LCD indicators Front panel ON/OFF button Power cord Power cord Signal receiver ON/OFF button ON/OFF button Operation Indication
Operating Instructions ENGLISH Operating Instructions How to insert the Batteries 1. Remove the battery cover by pulling it according to the arrow direction. 2. Insert new batteries making sure that the (+) and (-) of battery are installed correctly. 3. Reattach the cover by sliding it back into position. NOTE 1. Always use/replace both batteries of same type. 2. If the system is not to be used for a long time, remove the batteries to save their working life. 3.
Operating Instructions Wireless Remote Controller The controls will look like the following. Signal transmitter 14 1 10 4 3 2 18 6 7 5 17 8 13 9 15 11 16 8 12 Operation Mode Used to set auto clean mode. 14. PLASMA BUTTON Used to start or stop the plasma-purification function. 15. CLEAR ALL BUTTON Used to cancel all timer setting. 16. ENERGY SAVING COOLING BUTTON(OPTIONAL) Used to save Energy. Cooling Operation Auto Operation or Auto Changeover Healthy Dehumidification Operation 17.
Operating Instructions ENGLISH Operation Mode 1 Press the ON/OFF BUTTON to turn the unit on. The unit will respond with a beep. 2 Open the door of the remote controller and press the operation mode button. Each time the button is pressed, the operation mode is shifted in the direction of the arrow.
Operating Instructions Healthy Dehumidification Operation During Healthy Dehumidification Operation o If you select the dehumidification mode on the OPERATION MODE SELECTION BUTTON, the product starts to run the dehumidification function. It automatically sets the room temperature and airflow volume to the best condition for dehumidification, based on the sensed current room temperature.
Operating Instructions Jet cool function can be used to cool the room quickly in hot summer. When this function is turned on, the air conditioner runs in cooling operation mode with super high fan speed and 18°C setting temperature for 30 minutes for fast and effective cooling. Similarly, jet heat function (available only in some models) warms up the room quickly by operating at super high fan speed and 30°C setting temperature for 60 minutes.
Operating Instructions Energy-Saving Cooling Mode (Optional) Energy-saving cooling mode can save energy in cooling and healthy dehumidification operation, because it can operate efficiently by setting body-adaptation time according to the change of time and temperature and adjusting automatically desired temperature. 1. Press the ON/OFF BUTTON to start the unit. 2. Open the door of the remote controller. Select cooling operation or healthy dehumidification operation. 3.
Operating Instructions 1. Press the TIMER BUTTON for 3 seconds. 3. Press the SET / CLEAR BUTTON. 2. Press TIME SETTING BUTTONS until the desired time is set. NOTE Check the indicator for A.M. and P.M. Timer Setting 1. Press the TIMER BUTTON to turn timer on or off. 3. Press the SET / CLEAR BUTTON. 2. Press TIME SETTING BUTTONS until the desired time is set. NOTE Select one of the following 2 types of operation.
Operating Instructions Vertical / Horizontal Airflow Direction Control (Optional) The up/down airflow (Vertical airflow) can be adjusted by using the remote controller. The left/right(Horizontal airflow) can be adjusted by using the remote control. 1. Press the ON/OFF BUTTON to start the unit. 1. Press the ON/OFF BUTTON to start the unit. 2. Press CHAOS SWING BUTTON. 2. Press the HORIZONTAL AIRFLOW DIRECTION BUTTON. 3. The louvers will swing up & down automatically. 4.
Maintenance and Service ENGLISH Maintenance and Service Before performing any maintenance, turn off the main power to the system, disconnect the circuit breaker and unplug the power cord. Indoor Unit Clean the unit with a soft dry cloth. Do not use bleach or abrasives. Never use any of these • Water hotter than 40°C. It may cause deformation and discoloration. • Volatile substances. They may damage the surface of the air conditioner.
Maintenance and Service Type 2: Pull the front panel from both sides as shown. Then pull the filter tab slightly forward to remove the filter. After removing the air filter remove the plasma and triple deodorizer filter by slightly pulling forward. Deodorizer filter Plasma filter Don't touch this plasma filter within 10 seconds after opening the inlet grille, it may cause an electric shock. 2.
Maintenance and Service Plasma filter Front panel Panel hook After cleaning and drying well reinstall the filters in their original position. 6. Deluxe (Type 2): Open the front panel as shown. Then pull the filter tab slightly forward to remove the air filter. After removing the air filter remove the plasma and deodorizer filter by slightly pulling forward. Plasma filter Front panel How to use the front panel 1. Front panel closing Move the link upward and close the front panel. 2.
Maintenance and Service How to replace picture & photograph (Art Cool Type2) 1. Turn off power and then open the upper part of front panel. 4. Take out picture. 2. Pull out the both links of lower part of front panel, as described in the below picture. 5. Turn upside-down of the picture and turn over mat, then take off a protective tape attached at the mat. 3. Push and close the top part of the front panel and then pull the bottom part of the panel forward until it is secured. 6.
Maintenance and Service The heat exchanger coils and panel vents of the outdoor unit should be checked regularly. If clogged with dirt or soot, the heat exchanger and panel vents may be professionally steam cleaned. NOTE Dirty or clogged coils will reduce the operating efficiency of the system and cause higher operating costs. Operation Tips! Do not overcool the room. Keep blinds or curtains closed. This is not good for the health and wastes electricity.
Maintenance and Service Troubleshooting Tips! Save time and money! The air conditioner may be operating abnormally when: Problem Air conditioner does not start Air conditioner does not cool as it should Possible Causes What To Do n The air conditioner is unplugged. • Make sure the air conditioner plug is pushed completely into the outlet. n The fuse is blown/circuit breaker is tripped. • Check the house fuse/circuit breaker box and replace the fuse or reset the breaker. n Power failure.
