User guide
4
SAFETY PRECAUTIONS
Do not place the product close to
sources of steam, oil or oil mist, such
as humidifiers and kitchen counters.
- Failure to do so may result in fire,
electric shock, or corrosion.
Do not install the product onto a wall
or ceiling that is close to sources of
oil or oil mist.
- The product may be damaged and
fall, resulting in serious injury.
Do not place the projector where it
might be exposed to dust.
- Otherwise, this may result in fire.
Do not use the projector in a damp
place, such as a bathroom where it is
likely to get wet.
- This may cause fire or electric shock.
Make sure the air vent is not blocked
by a tablecloth or curtain.
- This could result in fire due to in-
creased internal temperature.
When using the projector, make sure
that the air vents (air filters) at the
bottom of the product are not blocked.
Make sure there is good ventilation
around the projector. The distance
between the projector and wall should
be more than 30 cm.
- Doing so may result in a fire due to
increased internal temperature.
CAUTION
When placing the projector on a table
or shelf, be careful not to put it near
the edge.
- The projector could fall, causing
injury and damage to the projector.
Only use a suitable stand.
Disconnect the projector from the
power supply and all connected ap-
paratuses before moving or cleaning.
- The power cord may be damaged
and create a fire hazard or result in
electric shock.
Do not place the projector on an
unstable or vibrating surface, such as
a wobbly shelf or on a slope.
- It may fall and cause injury.
Make sure that the projector does not
fall when connecting it to an external
device.
- It may cause personal injury or dam-
age to the product.
Power
WARNING
The ground cable should be connected.
- Make sure that you connect the
ground cable to prevent possible
electric shock. If it is not possible
to ground the unit, have a qualied
electrician install a separate circuit
breaker. Do not try to ground the pro-
jector by connecting it to telephone
wires, lightning rods, or gas pipes.
The power plug should be inserted
fully into the power outlet.
- An unstable connection may cause
fire.
Do not place heavy objects on the
power cord.
- This may cause fire or electric shock.
Never touch the power plug with wet
hands.
- This may result in electric shock or fire.
Do not plug too many devices into
one multipower outlet or power strip.
- This may result in the power outlet
overheating and creating a fire hazard.
Prevent dust from collecting on the
power plug pins or outlet.
- This may result in electric shock or
fire.