User manual

10
ENG
ENGLISH
10
EXTERNAL CONTROL DEVICE SETUP
21. Input select (Command: x b)
(Main Picture Input)
► To select input source for main picture.
(Use the feature depending on your model.)
Transmission [x][b][ ][Set ID][ ][Data][Cr]
Ack [b][ ][Set ID][ ][OK/NG][Data][x]
* In case external input data is DTV, Input number ‘0’ is
AIR, ‘1’ is CATV and ‘2’ is SATELLITE.
Data
Data Input
0x00 DTV
0x01 CADTV
0x02 Sat DTV
0x10 ATV
0x11 CATV
0x20 AV1
0x21 AV2
0x22 AV3
0x40 Component1
0x41 Component2
0x42 Component3
0x60 RGB
0x70/80/90/a0 HDMI1
0x71/81/91/a1 HDMI2
0x72/82/92/a2 HDMI3
0x73/83/93/a3 HDMI4
22. 3D (Command: x t) (Only 3D models)
► To change 3D mode for TV.
Transmission [x][t][ ][Set ID][ ][Data01][ ][Data02]
[ ][Data03][ ][Data04][Cr]
Data01 00 : 3D On
01 : 3D Off
02 : 3D to 2D
03 : 2D to 3D
Data02 00 : Top and Bottom
01 : Side by Side
02 : Check Board
03 : Single Frame Sequential
04 : Column interleaving
05 : Row interleaving
Data03 00 : Right to Left
01 : Left to Right
Data04 3D Depth : Min: 00 to Max: 14
* Refer to ‘Real data mapping’. (See p.9)
* If data01 is 01(3D off), data2, data3 and data4 have no
meaning.
* If data01 is 02(3D to 2D), data2, data3 and data4 have
no meaning.
* If data01 is 03(2D to 3D), data2 and data3 have no
meaning.
Ack [t][ ][OK][Data01][Data02][Data03][Data04][x]
[t][ ][NG][Data01][x]
Data01 Data02 Data03 Data04
00 O O X
01 X X X
02 X X X
03 X X O
X : Don't care