User manual

ASSEMBLING AND PREPARING

ENG

ENGLISH

Mounting on a table

Lift and tilt the TV into its upright position on a

table.

- Leave a 10 cm (minimum) space from the

wall for proper ventilation.

Connect the power cord to a wall outlet.

Securing the TV to a table

Fix the TV to a table to prevent from tilting forward,

damage, and potential injury.

Mount the TV on a table, and then insert and

tighten the supplied screw on the rear of the stand.

(Only 32/42/47LS669*, 32/42CS669*)

Adjusting the angle of the TV to suit view

(Only 32/42/47LS669*, 32/42/47CS669*)

Swivel 20 degrees to the left or right and adjust the

angle of the TV to suit your view.

CAUTION

Do not place the TV near or on sources

of heat, as this may result in fire or other

damage.

WARNING

To prevent TV from falling over, the TV

should be securely attached to the floor/

wall per installation instructions. Tipping,

shaking, or rocking the TV may cause injury.

(Only 42/47/55LM610*)

Swivel 10 degrees to the left or right and adjust the

angle of the TV to suit your view.

1010

CAUTION

When adjusting the angle of the product,

watch out for your fingers.

- Personal injury may occur if hands or

fingers are pinched. If the product is tilted

too much, it may fall, causing damage or

injury.

(Only 42/47/55LM610*)