User guide
CONNECTIONS & SETUP
27
NOTE
!
To enjoy vivid picture and sound, connect a PC to
the set.
Avoid keeping a fixed image on the set’s screen
for a long period of time. The fixed image may
become permanently imprinted on the screen;
use a screen saver when possible.
Connect PC to the RGB INPUT(PC INPUT) port
of the set; change the resolution output of PC
accordingly.
There might be a noise according to some reso-
lution, vertical pattern, contrast or brightness in
PC mode. Then change the PC mode into other
resolution or change the refresh rate into other
rate or adjust the brightness and contrast on the
menu until the picture is clean. If the refresh rate
of the PC graphic card can not be changed,
change the PC graphic card or consult it to the
manufacturer of the PC graphic card.
The synchronization input form for Horizontal
and Vertical frequencies is separate.
We recommend using 640x480, 60Hz
(42PC1RV/42PC1RVH)/1360x768, 60Hz
(26/32LC2R/32LC3R/42PC1R/42PC7R/42PC7RH)
for the PC mode, they provide the best picture
quality.
If the resolution of PC is over UXGA, there will be
no picture on the set.
Connect the audio cable from the PC to the
Audio input on the set. (Audio cables are not
included with the set).
When you use too long RGB-PC cable, there
might be a noise on the screen. We recommend
using under 5m of the cable. It provides the best
picture quality.
This set does not support HDMI-PC.
RGB-PC 640*350 mode is only for DOS, it is
possible that dose not full the whole screen.
44
55
1
2
3
6
7
8
9
PC SETUP
REMOTE
CONTROL IN
RS-232C IN
(CONTROL
&
SERVICE)
HDMI IN
AUDIO OUT
VARIABLE
RGB INRGB IN
(PC/DTV)
AUDIO IN
(RGB)
AUDIO
RGB-PC OUTPUT
PC
1
2
■
This TV provides Plug and Play capability, meaning that the PC adjusts automatically to the TV's settings.
When connecting with a D-sub 15 pin cable
Connect the RGB output of the PC to the
RRGGBB IINN
((PPCC//DDTTVV))
jack on the set.
Connect the audio outputs of the PC to the
AAUUDDIIOO IINN
((RRGGBB//DDVVII))
jack on the set.
Turn on the PC and the set.
1
2
3
Select
RRGGBB--PPCC
input source with using the
IINNPPUUTT
button
on the remote control.
4
10
11