SDS

General ventilation.
Wear eye/face protection.
Wear suitable gloves. Chemical protection gloves are suitable, which are tested according to EN 374. Check leak-
tightness/impermeability prior to use. In the case of wanting to use the gloves again, clean them before taking off and air
them well. For special purposes, it is recommended to check the resistance to chemicals of the protective gloves men-
tioned above together with the supplier of these gloves.
Take recovery periods for skin regeneration. Preventive skin protection (barrier creams/ointments) is recommended.
Wash hands thoroughly after handling.
In case of inadequate ventilation wear respiratory protection.
Use appropriate container to avoid environmental contamination. Keep away from drains, surface and ground water.
SECTION 8: Exposure controls/personal protection
8.1 Control parameters
Occupational exposure limit values (Workplace Exposure Limits)
Coun-
try
Name of sub-
stance
CAS No Notation Identifier TWA
[ppm]
TWA
[mg/m³]
STEL
[ppm]
STEL
[mg/m³]
US sodium hydroxide 1310-73-2 PEL 2
Notation
STEL short-term exposure limit: a limit value above which exposure should not occur and which is related to a 15-minute period un-
less otherwise specified
TWA time-weighted average (long-term exposure limit): measured or calculated in relation to a reference period of 8 hours time-
weighted average
8.2 Exposure controls
Appropriate engineering controls
Individual protection measures (personal protective equipment)
Eye/face protection
Skin protection
- Hand protection
- Other protection measures
Respiratory protection
Environmental exposure controls
Safety Data Sheet
acc. to 29 CFR 1910.1200 App D
Lexol® Leather Conditioner
Version number: 1.2 Date of compilation: 2017-09-22
United States: en
HANDSTANDS 000033 SDS-14:
Page: 5 / 11