Quick Reference Guide

6
Understanding printer messages
The following table lists some typical operator panel messages
you may encounter and the action you can take to clear them. For
more information on these or other printer messages, refer to the
Lexmark C910 Publications CD.
Message Action
37 Insufficient Memory
The printer memory isn’t
sufficient and cannot
continue processing print
jobs.
• Press Go to clear the message. The
printer deletes held jobs until there
is enough printer memory to
process the current job.
• Press Stop to clear the message
without deleting any held jobs. The
current job may not print correctly.
• Press Menu to open the Job Menu,
and then press Select to cancel the
current job.
Note: The messages 37
Insufficient Memory and Held
Jobs may be lost alternate on the
display.
38 Memory Full
The printer is processing
data, but the memory used to
store pages is full.
• Press Go to clear the message and
continue printing the job. The job
may not print correctly.
• Press Menu to open the Job Menu,
and then press Select to cancel the
current job.
39 Complex Page
The page may not print
correctly because the print
information on the page is
too complex.
• Press Go to clear the message and
continue printing the job. The job
may not print correctly.
• Press Menu to open the Job Menu,
and then press Select to cancel the
current job.
80 Fuser Exhausted
It is time for you to replace
the fuser.
• Press Go to clear the message.
• Install a new fuser.
Note: If the front door is opened and
closed, the message Did you
replace fuser? appears. If a new
fuser has not been installed, press
Stop. If a new fuser has been installed,
press Go.