Printer User Manual
Table Of Contents
- Introduction
- Set Initial Conditions (SIC) Command
- IBM Emulation Mode Printer Commands
- Control Codes
- Escape Sequences
- Printer Command Parameters
- Command Structure
- Printer Command Quick Reference (IBM Emulation Mode)
- Selecting a Character Set
- Select Code Page
- Print From Code Page
- Download a Character Set
- Select Global Font
- Select Print Type Style
- Set Print Quality
- Graphics Print Modes
- Horizontal Movement
- Line Control
- Vertical Tabulation
- Line Spacing
- Set Top of Form and Page Length
- Printer Control
- Epson Emulation Mode Printer Commands
- OKI Microline Emulation Mode Printer Commands
- Using the Printer Interface
- Downloading Characters and Fonts
- Barcodes
- Code Pages
- Glossary
- Index
45
Section 3: IBM Emulation Mode Printer Commands
Superscript or Subscript
To begin superscript:
To end superscript:
To begin subscript:
To end subscript:
Set Print Direction
This command sets the printer to print either unidirectionally or bidirectionally.
Usage Note
The value of n can be any of the following:
Format ESC S n
Decimal 27 83 0
Hex 1B 53 00
Format ESC T
Decimal 27 84
Hex 1B 54
Format ESC S n
Decimal 27 83 1
Hex 1B 53 01
Format ESC T
Decimal 27 84
Hex 1B 54
Format ESC U n
Decimal 27 85 n
Hex 1B 55 n
Decimal Hex Direction
0 00 bidirectional (both directions)
1 01 Unidirectional (left to right)