Printer User Manual
Table Of Contents
- Introduction
- Set Initial Conditions (SIC) Command
- IBM Emulation Mode Printer Commands
- Control Codes
- Escape Sequences
- Printer Command Parameters
- Command Structure
- Printer Command Quick Reference (IBM Emulation Mode)
- Selecting a Character Set
- Select Code Page
- Print From Code Page
- Download a Character Set
- Select Global Font
- Select Print Type Style
- Set Print Quality
- Graphics Print Modes
- Horizontal Movement
- Line Control
- Vertical Tabulation
- Line Spacing
- Set Top of Form and Page Length
- Printer Control
- Epson Emulation Mode Printer Commands
- OKI Microline Emulation Mode Printer Commands
- Using the Printer Interface
- Downloading Characters and Fonts
- Barcodes
- Code Pages
- Glossary
- Index
Section 8: Barcodes
180
• The desired barcode may not print if invalid characters are specified in the
data transfer command.
Example:
Since the desired barcode is POSTNET (B9), the letter ’a’ is not a valid
character. The numbers ’0’-’9’ are the only valid characters for POSTNET.
<x
1B5B66 - barcode setup command prefix
0600 - setup data length (low byte first) -
x0006, 6
B9 - barcode type = POSTNET
00 - module width = default
00 - space width adjustment = default
0E01 - height (low byte first) - x010E =
0.125 inches
00 - control byte
1B5B70 - barcode data transfer command prefix
0500 - data transfer length (low byte first)
- x0005, 5
>012a5 ...