user manual
Table Of Contents
- Contents
- About your printer
- Ordering and replacing ink cartridges
- Using the printer software
- Printing
- Copying
- Scanning
- E-mailing
- Wireless networking
- Troubleshooting
- Before you troubleshoot
- If Troubleshooting does not solve your problem
- Setup troubleshooting
- Installation screen did not appear during installation
- Incorrect language appears on the display
- Software did not install
- Print job does not print or is missing pages
- Make sure the ink cartridges are inserted correctly
- Select your printer from the Print dialog before sending the print job
- Make sure the print job is not paused
- Make sure your printer is set as the default printer
- Reconnect the printer power supply
- Remove and reconnect the USB cable connected to your printer
- Check the USB connection
- Remove and reinstall the printer software
- Printer is printing blank pages
- Printer is busy or does not respond
- Cannot delete documents from the print queue
- Cannot print through USB
- Wireless network troubleshooting
- Wireless troubleshooting checklist
- Printing a network setup page
- Locating IP addresses
- Cannot print over wireless network
- Turn the access point (wireless router) off and then back on
- Disconnect from VPN session
- Make sure Demo Mode is turned off
- Check your WEP key or WPA passphrase
- Check if your access point has an association/registration button
- Move your access point away from other electronic devices
- Move the computer and/or printer closer to the access point
- Check the wireless signal quality
- Check your advanced security settings
- Make sure your computer is connected to your access point
- Make sure that your computer and printer are connected to the same wireless network
- Make sure your OS is compatible with wireless printing through AirPort
- “Communication not available” message appears when printing wirelessly
- Notices
- Index
Use To
9 Cancel
• Cancel a print, copy, or scan job in progress.
• Clear current settings or error messages, and return to previous
settings.
10 Wi‑Fi indicator
Check the wireless status of your printer.
11 Eco‑Mode
• Change to Sleep mode after the printer is left idle for 10 minutes.
• Reduce the screen brightness.
12 Back
• Return to the previous screen.
• Exit from one menu level to a higher one.
Using flash drives
Supported file types
• .jpg, .jpeg, .jpe (Joint Photographic Experts Group)
• .tiff, .tif (Tagged Image File Format)
Using a flash drive with the printer
Make sure the flash drive contains files that are supported by the printer. For more information, see
“Supported file types” on page 13.
1 Insert a flash drive into the USB port.
F
L
A
S
H
D
R
I
V
E
Notes:
• The flash drive uses the same port that is used for a PictBridge camera cable.
• An adapter may be necessary if your flash drive does not fit directly into the port.
Warning—Potential Damage: Do not touch any cables,
any network adapter, any connector, the memory
device, or the printer in the areas shown while actively
printing, reading, or writing from the memory device. A
loss of data can occur.
2 Follow the instructions or select from available options on the printer display.
Note: If the printer does not recognize the memory device, then remove and reinsert it.
About your printer 13