User Manual

3 Remove the extra trays.
4 Connect the power cord to a properly grounded electrical outlet.
5 Turn the printer back on.
Unformatted flash detected [53]
Try one or more of the following:
• From the printer control, select Continue to stop the defragmentation and continue printing. For
non‑touch‑screen printer models, press
to
confirm.
• Format the
flash
memory.
Note: If the error message remains, then the flash memory may be defective and need to be replaced.
Unsupported option in slot [x] [55]
1 Turn o the printer.
2 Unplug the power cord from the electrical outlet.
3 Remove the unsupported option card from the printer controller board, and then replace it with a
supported card.
4 Connect the power cord to a properly grounded electrical outlet.
5 Turn the printer back on.
Weblink server not set up. Contact system administrator.
Select Continue to clear the message. For non‑touch‑screen printer models, press to confirm.
Note: If the message appears again, then contact your system support person.
Solving printer problems
• “Basic printer problems” on page 194
• “Option problems” on page 196
• “Paper feed problems” on page 199
Troubleshooting 193