User Manual

• From the printer control panel, select Continue to continue printing. For non‑touch‑screen printer
models, press
to
confirm.
• Turn o the printer, and then turn it back on.
SMTP server not set up. Contact system administrator.
From the printer control panel, select Continue to clear the message. For non‑touch‑screen printer models,
press
to confirm.
Note: If the message appears again, then contact your system support person.
Standard network software error [54]
Try one or more of the following:
• From the printer control panel, press to
confirm.
• Unplug the router, wait for 30 seconds, and then plug it back again.
• Turn o the printer, and then turn it back on.
• Update the network firmware in the printer or the print server. For more information, visit the Lexmark
support Web site at
http://support.lexmark.com.
Standard USB port disabled [56]
From the printer control panel, select Continue to clear the message. For non‑touch‑screen printer models,
press
to confirm.
Notes:
• The printer discards any data received through the USB port.
• Make sure the USB
Buer
menu is not set to Disabled.
Too many flash options installed [58]
1 Turn
o
the printer.
2 Unplug the power cord from the electrical outlet.
3 Remove the extra
flash
memory.
4 Connect the power cord to a properly grounded electrical outlet.
5 Turn the printer back on.
Too many trays attached [58]
1 Turn
o
the printer.
2 Unplug the power cord from the electrical outlet.
Troubleshooting 192