User Manual

4 Push the memory card straight into the connector and forward into the controller board wall until it clicks

into place.

5 For the MS510dn, MS517dn, MS610dn, and MS617dn printer models, close the controller board access door.

For the MS610de printer model, close the controller board shield, and then close the access door.

Note: When the printer software and any hardware options are installed, add the options manually in the

print driver to make them available for print jobs. For more information, see

“Adding available options in the

print driver” on page 29.

Installing an Internal Solutions Port

The controller board supports one optional Lexmark

Internal Solutions Port (ISP). This option is supported

only in MS610de printer model.

Note: This task requires a

ﬂat

‑head screwdriver.

CAUTION—SHOCK HAZARD: If you are accessing the controller board or installing optional hardware

or memory devices sometime after setting up the printer, then turn the printer o, and unplug the power

cord from the electrical outlet before continuing. If you have any other devices attached to the printer,

then turn them o as well, and unplug any cables going into the printer.

Additional printer setup 16