User Manual

12
10. Specications 11. Accessories
// LCT 40 SH - shock mount
A shock mount is recommended for most recording applications as it reduces
unwanted structure-borne noise. The front of the microphone is indicated by
the Lewitt logo. The open front of the shock mount allows you to position the
microphone as close as you like to the source.
// LCT 50 PSx - magnetic pop lter
The magnetic pop lter was designed to perfectly integrate with the design of the
microphone and its shock mount. A pop lter not only helps to avoid plosives and
hisses on your recording, but also protects the condenser capsule from being
exposed to moisture.
// LCT 40 Wx – windscreen
This one is especially useful when using the microphone outdoors, to shield the
capsule from wind. Can also be used for vocal recordings, to protect the capsule
from moisture.
// DTP 40 Lb - transport bag
Microphones which are not in use should not remain on the stand gathering dust
or be unnecessarily exposed to humidity. Unmount it from the shock mount and
put it into the supplied DTP 40 Lb transport bag.
// Protective case
The military-grade protective case made of nearly indestructible material offer
you comprehensive protection for your microphone.
Type Condenser, externally polarized
Acoustical operating principle
Pressure gradient transducer
Diaphragm 3 micron gold sputtered Mylar
Transducer Ø 25.4 mm, 1 in
Polar pattern Cardioid
Sensitivity 41 mV/Pa, -28 dBV/Pa
Signal / noise ratio 90 dB (A)
Dynamic range 132 dB (A)
Equivalent noise level 4 dB (A)
Max. SPL for 0.5 % THD 136 dBSPL, 0 dB pre-attenuation
Supply voltage 48 V +/- 4 V
Current consumption 3.6 mA
Internal impedance 68 Ω
Connector Gold plated 3-pin XLR
Mic enclosure Zinc die cast
Microphone dimensions 158 x 52 x 36 mm, 6.22 x 2.04 x 1.42 in
Microphone net weight 371 g, 13.1 oz
Table 10.1